Characterizing and modelling the perpendicular to the grain mode-I fracture process of (tropical) hardwood

Characterizing and modelling the perpendicular to the grain mode-I fracture process of (tropical) hardwood

Rademaker, Rolf (TU Delft Civil Engineering & Geosciences)

Ravenshorst, G.J.P. (mentor)
van de Kuilen, J.W.G. (graduation committee)
Esposito, R. (graduation committee)
Mirra, M. (graduation committee)
Mosleh, Yasmine (graduation committee)

Delft University of Technology

Civil Engineering | Structural Engineering | Structural Mechanics

2022-12-08

The demand to build with wood and other bio-based materials has increased rapidly the last decade, due to the ambition to build more with sustainable building materials. One of the major challenges in building with wood, is to account for the lower strength and stiffness perpendicular to the grain. Wood is an anisotropic material, meaning the material has different properties in different directions. Loading in the perpendicular to the grain direction is sometimes unavoidable and fracture often occurs in a brittle manner. Unfortunately, our understanding and knowledge of the perpendicular to the grain fracture is limited. This is especially the case for hardwoods, for which the material properties and the parameters important for the fracture process are often unknown.

The goal of this thesis is to reduce this knowledge gap on the material properties and the relevant parameters in mode-I (pure tension) fracture process of (tropical) hardwood. The knowledge gained in this research provides the answer to the main research question of this thesis: Which parameters should be considered when describing the constitutive model of a (tropical) hardwood in mode-I tension?

A single-end notch three-point bending (SEN-TPB) test demonstrated a strong influence of the orientation of the growth rings on the perpendicular to the grain fracture process of azobé. The value for the peak load and post-peak behaviour change significantly depending on the orientation in which the sample is placed. Furthermore, visual observations and results from a profilometer revealed that there is an inconsistency in the roughness of the cracked surface area between the different series. From the microscopic analysis is concluded that this inconsistency in general mechanical behaviour and the roughness of the cracked surface area is linked to the composition of ray and parenchyma cells. Moreover, the direction of the ray and parenchyma cells with respect to the fracture plane is different depending on the orientation of the sample. When the ray cells are orientated perpendicular to the crack plane, a higher strength is obtained. The thin-walled parenchyma cells significantly reduce the post-elastic stiffness if these cells are orientated perpendicular to the crack plane. The influence of the composition and orientation of both cells is reflected in the numerical value for the modulus of elasticity, the tensile strength and the fracture energy. This research showed that the composition of the cells in a wood specie and the orientation in which the growth rings are placed significantly influence the mode-I fracture process of a hardwood. This influence is reflected in the modulus of elasticity, the tensile strength, the fracture energy and the shape of the tension softening curve perpendicular to the grain. The results of this research provide new insight into the fracture modelling of hardwood. Both in numerical modelling and design considerations the variation in the material properties because of the orientation of the growth rings, should not be neglected.

Timber
fracture behaviour
Fracture energy
Hardwood
Mode I
Azobé

http://resolver.tudelft.nl/uuid:101144b1-3585-444f-9def-360b6e9c835a

Student theses

master thesis

© 2022 Rolf Rademaker