Numerical estimation of wave loads on crest walls on top of rubble mound breakwaters using OpenFOAM

Numerical estimation of wave loads on crest walls on top of rubble mound breakwaters using OpenFOAM

Irias Mata, Marisol (TU Delft Civil Engineering & Geosciences)

Antonini, A. (mentor)
van Gent, M.R.A. (graduation committee)
Zijlema, Marcel (graduation committee)
van der Lem, Cock (graduation committee)
Boersen, Stef (graduation committee)
Jansen, Bjarne (graduation committee)

Delft University of Technology

Civil Engineering | Hydraulic Engineering

2021-09-29

The design of hydraulic structures like breakwaters and crest walls is often based on empirical formulations, physical models test, numerical models and a fair amount of expert judgement. Each technique has its own pros and cons. The main limitation of the empirical formulas is that often they have to be applied outside their range of validity. Physical modelling also has its own shortcomings. When breaking waves hit the structure, the location of the maximum pressures is still not well known due to the high spatial variability. By using an array with low spatial resolution, the forces estimated in the physical ume will usually underestimate to some extent the actual forces experienced by the wall (Ramachandran et al., 2013). In the last decades, numerical modelling has become an attractive alternative in simulating wave-structure interactions. Nevertheless, estimating loads on crest walls in the numerical ume is still at its early stages. On that account, the present work validates the prediction of wave induced forces on the front face of crest walls on top of rubble mound breakwaters in CoastalFOAM. A scale model of the Holyhead breakwater, located in Wales, is used. The key validation topics are the reproduction of wave-structure interaction when heavily breaking waves reached the wall, the evaluation of the ventilated boundary condition implemented by Jacobsen et al. (2018), the porous ow inside the armour layer formed by Tetrapods units and whether the simplication of not using a turbulence model, as done by Jensen et al. (2014) and Jacobsen et al. (2018), is also valid under heavily breaking waves. Four validation cases were used to test the capabilities of the numerical ume. The results conrm that it is possible to accurately reproduce the wave conditions and the wave induced forces from a physical modelling campaign. Overall, the CoastalFOAM model is able to capture the shape and the order of magnitude of the force events. A calibrated model predicts the highest wave induced forces (forces with an exceedance probability of 0.4% and 0.1%) with errors lower than 20%. Moreover, the results indicate that for practical applications it is not essential to include a turbulence model in the numerical ume to obtain reliable forces on the front face of crest walls for dierent wave conditions. Another outcome of this study is that the implementation of the ventilated boundary condition is required in the interface between water surface and structural elements to mimic accordingly the air-water mixture when the structure is subjected to a heavy wave attack. Nonetheless, there is still room for improvement in this area, where a better understanding of this boundary condition and of the air entrapment during wave-structure interaction needs further research. Despite the large computational time required by the numerical ume when large wave trains must be simulated, a CFD model during design stages of breakwaters and crest walls provides higher spatial and temporal resolution of the wave induced pressures exerted on the wall than a physical test. Therefore, a better picture of the forces and pressure distribution in the front face can be obtained.

OpenFOAM
waves2FOAM
Rubble mound breakwater
crown wall loading
Tetrapods
Breaking wave impact

http://resolver.tudelft.nl/uuid:36b66c90-dfdb-41d0-b1f2-1253d3f87b4c

Student theses

master thesis

© 2021 Marisol Irias Mata