Numerical analysis and discussion on the hot-spot stress concept applied to welded tubular KT joints

Numerical analysis and discussion on the hot-spot stress concept applied to welded tubular KT joints

Vieira Ávila, Bianca (Universidade Federal de Minas Gerais)
Correia, J.A.F.O. (TU Delft Steel & Composite Structures)
Carvalho, Hermes (Universidade Federal de Minas Gerais)
Fantuzzi, Nicholas (University of Bologna)
De Jesus, Abílio (Universidade do Porto)
Berto, Filippo (Norwegian University of Science and Technology (NTNU))

2022

Nominal stresses have been used for a long time for the assessment of fatigue resistance of welded joints, however, this approach has strong limitations since the definition of the nominal stress may be subjective for complex welded details and/or complex loading. On the other hand, the hot-spot stress approach has been proposed to overcome these limitations considering the structural geometrical discontinuities. However, the hot-spot stress methods also present certain limitations, and the present study aims at evaluating the available numerical and analytical hot-spot stress methods proposed by DNVGL (2016) and IIW (2014). The particular case of an offshore tubular KT joint has been considered herein and discretized in two planes. It has been studied numerically using the ABAQUS software coupled with the hot-spot stress extrapolation methods described in IIW (2014) and DNVGL (2016). The influence of the weld geometry has been considered and evaluated. In addition to the numerical method, the present study has also considered the analytical approach proposed in DNVGL (2016) derived from the combination of Efthymiou solutions for the stress concentration factor with the method of superposition of stresses. The numerical models according to IIW (2014) have been found to be more conservative when compared with the mesh-size methods proposed by DNVGL (2016), both in numerical modelling without the weld or with weld. For the numerical models with weld cord, the mean values of normalized difference index obtained for all braces together, as a result of comparing numerical results with analytical solutions, are lower, when compared with results obtained from the numerical models without weld cord.

Analytical solutions
Extrapolation method
Finite element analysis
Hot-spot stress
Tubular joints

http://resolver.tudelft.nl/uuid:7286bf49-4581-4d05-b6e2-3f8648e7db9a

https://doi.org/10.1016/j.engfailanal.2022.106092

2023-07-01

1350-6307

Engineering Failure Analysis, 135

Green Open Access added to TU Delft Institutional Repository 'You share, we take care!' - Taverne project https://www.openaccess.nl/en/you-share-we-take-care Otherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public.

Institutional Repository

journal article

© 2022 Bianca Vieira Ávila, J.A.F.O. Correia, Hermes Carvalho, Nicholas Fantuzzi, Abílio De Jesus, Filippo Berto