Dike Pins

Dike Pins: A Parametric Study in Plaxis to assess the Current Design Approach and Future Applicability

Wever, Esther (TU Delft Civil Engineering and Geosciences)

Vardon, Phil (mentor)
Hicks, Michael (graduation committee)
Schweckendiek, Timo (graduation committee)
van IJken, R.W. (graduation committee)

Delft University of Technology

2018-06-12

One of the main challenges in dike design in the Netherlands is to guarantee a sufficient safety level against the development of macro-instabilities in a dike. A case study was performed on a dike section at Herrewijnen-Opijnen, which is part of the Heesseltse Uiterwaarden in the Dutch province of Gelderland. The dike located at this site no longer fulfils the required safety standards, and therefore dike reinforcement is required. This thesis focuses on reinforcing this dike with the new technique of dike pins. Dike pins are grouted steel anchors, that are installed in the dike crest to improve macro-stability. The case study shows that the governing geometrical parameter in design is the centre-to-centre distance of
the dike pins. The cohesion of the clay slope was the governing geotechnical parameter for the determination of the slope safety factor. Arching occurred for high values of the friction angle or the cohesion of the sand layer. A large decrease in the bending moment of the dike pin results from arching. In this parametric study, correspondence was found between the 2D and 3D Plaxis models in terms of slope safety factor and in terms of the development of internal moments in the dike pin. A design scheme was suggested, which shows that in most cases a 2D design method may be chosen. The proposed design scheme simplifies the design method for dike pins.

dike pin slope stability

http://resolver.tudelft.nl/uuid:aa2c5966-8d7d-4595-8da9-6673bc9ffe2f

2047-07-31

Student theses

master thesis

© 2018 Esther Wever