Searched for:
(1 - 20 of 117)

Pages

document
Liao, B. B. (author), Wang, D. L. (author), Hamdi, M. (author), Zheng, J. Y. (author), Jiang, P. (author), Gu, C. H. (author), Hong, W. R. (author)
This paper aims to characterize the damage mechanisms of 70 MPa Type IV hydrogen composite pressure vessels using the acoustic emission (AE) method. First, AE signals were captured during the 0–105 MPa and 0–158 MPa hydraulic tests of two vessels using multi-step loading method. Second, the AE feature parameters in time-domain and frequency...
journal article 2019
document
Jiang, J. (author)
This Ph.D. dissertation describes the theory and realization of wide-bandwidth magnetic sensors for current measurements which breach the conventional offset and noise constraints in CMOS processes. These are achieved by several circuit-level and system-level innovations, including the use of three orthogonal ripple reduction loops (RRLs) in...
doctoral thesis 2019
document
Ekka, A. (author), Pande, S. (author), Jiang, Yong (author), van der Zaag, P. (author)
poster 2019
document
Jiang, H. (author), Nihtianov, S. (author), Makinwa, K.A.A. (author)
This paper describes an energy-efficient bridge readout IC (ROIC), which consists of a capacitively coupled instrumentation amplifier (CCIA) that drives a continuous-time delta–sigma modulator (CTM). By exploiting the CCIA’s ability<br/>to block dc common-mode voltages, the bridge’s bias voltage may exceed the ROIC’s supply voltage, allowing...
journal article 2019
document
Zhang, Jian (author), Sokolovskij, R. (author), Chen, Ganhui (author), Zhu, Yumeng (author), Qi, Yongle (author), Lin, Xinpeng (author), Li, Wenmao (author), Zhang, G. (author), Jiang, Yu-Long (author), Yu, Hongyu (author)
In this paper, a method to extend the detection range of hydrogen sulfide (H<sub>2</sub>S) gas sensor is demonstrated. The sensor is based on AlGaN/GaN high electron mobility transistors (HEMTs) with Pt gate. It is observed that the as-fabricated devices exhibited sensing signal saturation at 30 ppm H<sub>2</sub>S exposure in dry air. A pre...
journal article 2019
document
Hou, T. (author), Xu, J. (author), Elkhuizen, W.S. (author), Wang, C.C. (author), Jiang, Jiehui (author), Geraedts, J.M.P. (author), Song, Y. (author)
2D coil design limits the use of wireless power transfer (WPT) in many products with freeform outer shapes. In this paper, enabled by 3D printed electronics, we propose a systematic approach to design and fabricate 3D coils for WPT. Based on the circular spiral and rectangular spiral patterns, 3D receiver and transmitter coils can be...
journal article 2019
document
Jiang, Y. (author), Cucu Laurenciu, N. (author), Wang, H. (author), Cotofana, S.D. (author)
As CMOS feature size is reaching atomic dimensions, unjustifiable static power, reliability, and economic implications are exacerbating, thereby prompting for conducting research on new materials, devices, and/or computation paradigms. Within this context, graphene nanoribbons (GNRs), owing to graphene's excellent electronic properties, may...
journal article 2019
document
Jiang, Honglan (author), Liu, Leibo (author), Jonker, P.P. (author), Elliott, Duncan G. (author), Lombardi, Fabrizio (author), Han, Jie (author)
In this paper, a fixed-point finite impulse response adaptive filter is proposed using approximate distributed arithmetic (DA) circuits. In this design, the radix-8 Booth algorithm is used to reduce the number of partial products in the DA architecture, although no multiplication is explicitly performed. In addition, the partial products are...
journal article 2019
document
Jiang, Y. (author), Cucu Laurenciu, N. (author), Cotofana, S.D. (author)
In this paper, we augment a trapezoidal Quantum Point Contact topology with top gates to form a butterfly Graphene Nanoribbon (GNR) structure and demonstrate that by adjusting its topology, its conductance map can mirror basic Boolean functions, thus one can use such structures instead of transistors to build carbon-based gates and circuits....
journal article 2019
document
Dadisman, Ryan (author), Shen, Jiazhou (author), Feng, Hao (author), Crow, Lowell (author), Jiang, Chenyang (author), Wang, Tianhao (author), Zhang, Yuxuan (author), Bilheux, Hassina (author), Parnell, S. (author), More Authors (author)
Several methods of polarized neutron scattering call for a zero magnetic field (ZF) region to reduce magnetic field integral aberrations while preserving the neutron polarization. Though the design for large angle neutron scattering has been presented in various places, the design characterization and tuning has not been discussed before. In...
journal article 2019
document
Jiang, N. (author), Shang, R. (author), Heijman, Sebastiaan (author), Rietveld, L.C. (author)
High-silica zeolites have been found to be effective adsorbents for the removal of organic micro-pollutants (OMPs) from impaired water, including various pharmaceuticals, personal care products, industrial chemicals, etc. In this review, the properties and fundamentals of high-silica zeolites are summarised. Recent research on mechanisms and...
review 2018
document
Liu, Huimin (author), Jiang, Canhui (author), Liu, Y. (author), Hertogh, M.J.C.M. (author), Lyu, Xue (author)
The high uncertainty of megaproject results in increasing complexity in the decisionmaking and ultimately leads to different degrees of cost overrun and project delays. One of the critical reasons for cost overrun and delay is the optimism bias of decision makers. Although the previous literature has analyzed the cost overrun distribution of...
journal article 2018
document
Jiang, X. (author), Luo, Chengwei (author), Qiang, X. (author), Zhang, Qilin (author), Kolstein, M.H. (author), Bijlaard, F.S.K. (author)
To investigate the mechanical degradation of the shear properties of glass fiber-reinforced polymer (GFRP) laminates in bridge decks under hygrothermal aging effects, short-beam shear tests were performed following the ASTM test standard (ASTM D790-10A). Based on the coupled hygro-mechanical finite element (FE) analysis method, an inverse...
journal article 2018
document
Jin, C.J. (author), Knoop, V.L. (author), Jiang, Rui (author), Wang, Wei (author), Wang, Hao (author)
For traffic flow models, calibration and validation are essential. Cellular automaton (CA) models are a special class of models, describing the movement of vehicles in discretised space and time. However, the previous work on calibration and validation does not discuss CA models systematically. This study calibrates and validates a stochastic...
journal article 2018
document
Jiang, M. (author), Visser, O.W. (author), Prasetya, I.S.W.B. (author), Iosup, A. (author)
Mobile gaming is already a popular and lucrative market. However, the low performance and reduced power capacity of mobile devices severely limit the complexity of mobile games and the duration of their game sessions. To mitigate these issues, in this article, we explore using computation‐offloading, that is, allowing the compute‐intensive parts...
journal article 2018
document
Bartesaghi, D. (author), Ray, Aniruddha (author), Jiang, Junke (author), Bouwer, Ricardo K.M. (author), Tao, S. (author), Savenije, T.J. (author)
Tailoring the physical properties of hybrid lead metal halide APbX<sub>3</sub> perovskites by means of compositional engineering is one of the key factors contributing to the development of highly efficient and stable perovskite solar cells. While the beneficial effects of partial ionic replacement at the A- and X-sites are largely...
journal article 2018
document
Cai, J. (author), Jiang, X. (author), Lodewijks, G. (author)
A dent is one of the main structural damages that may affect ultimate strength. In this paper, the residual ultimate strength of dented metallic pipes subjected to a bending moment is quantitatively investigated. The numerical model is developed accounting for the variation of the dent length (l<sub>d</sub>), dent depth (d<sub>d</sub>), dent...
journal article 2018
document
Cai, J. (author), Jiang, X. (author), Lodewijks, G. (author), Pei, Zhiyong (author), Wu, Weiguo (author)
Numerical investigation is conducted in this paper on both intact and dented seamless metallic pipelines (diameter-to-thickness ratio D/t around 21), deploying nonlinear finite element method (FEM). A full numerical model is developed, capable of predicting the residual ultimate strength of pipes in terms of bending capacity (M<sub>cr</sub>)...
journal article 2018
document
Yuan, K. (author), Lavala, Jorge (author), Knoop, V.L. (author), Jiang, Rui (author), Hoogendoorn, S.P. (author)
Traffic flow downstream of the congestion is generally lower than the pre-queue capacity. This phenomenon is called the capacity drop. Recent empirical observations show a positive relationship between the speed in congestion and the queue discharge rate. Literature indicates that variations in driver behaviors can account for the capacity drop....
journal article 2018
document
Sokolovskij, R. (author), Zhang, J. (author), Jiang, Y (author), Chen, Ganhui (author), Zhang, G.Q. (author), Yu, Hongyu (author)
Wide bandgap gallium nitride material has highly favorable electronic properties for next generation power and high frequency electronic devices. A less widely studied application is highly miniaturized chemical and gas sensors capable of operating in harsh environment conditions. In this work we present our recent developments on design,...
conference paper 2018
Searched for:
(1 - 20 of 117)

Pages