Searched for:
(1 - 20 of 86)

Pages

document
Erasme, D. (author), Spiekman, L.H. (author), Herben, C.G.P. (author), Smit, M.K. (author), Groen, F.H. (author)
journal article 1997
document
Smit, P.B. (author), Janssen, T.T. (author), Herbers, T.H.C. (author)
Refractive focusing of swell waves can result in fast-scale variations in the wave statistics because of wave interference, which cannot be resolved by stochastic wave models based on the radiative transport equation. Quasi-coherent statistical theory does account for such statistical interferences and the associated wave inhomogeneities, but...
journal article 2015
document
Cuellar Lopez, J.S. (author), Smit, G. (author), Zadpoor, A.A. (author), Breedveld, P. (author)
In developing countries, prosthetic workshops are limited, difficult to reach, or even non-existent. Especially, fabrication of active, multi-articulated, and personalized hand prosthetic devices is often seen as a time-consuming and demanding process. An active prosthetic hand made through the fused deposition modelling technology and fully...
journal article 2018
document
Yakaboylu, O. (author), Harinck, J. (author), Smit, K.G. (author), De Jong, W. (author)
The supercritical water gasification process is an alternative to both conventional gasification as well as anaerobic digestion as it does not require drying and the process takes place at much shorter residence times; a few minutes at most. The drastic changes in the thermo-physical properties of water from the liquid state to the supercritical...
journal article 2014
document
Snik, F. (author), Rietjens, J.H.H. (author), Apituley, A. (author), Volten, H. (author), Mijling, B. (author), Di Noia, A. (author), Heikamp, S. (author), Heinsbroek, R.C. (author), Hasekamp, O.P. (author), Smit, J.M. (author), Vonk, J. (author), Stam, D.M. (author), Van Harten, G. (author), De Boer, J. (author), Keller, C.U. (author)
To assess the impact of atmospheric aerosols on health, climate, and air traffic, aerosol properties must be measured with fine spatial and temporal sampling. This can be achieved by actively involving citizens and the technology they own to form an atmospheric measurement network. We establish this new measurement strategy by developing and...
journal article 2014
document
Gulski, E. (author), Smit, J.J. (author), Wester, F.J. (author)
journal article 2005
document
Stulemeijer, J. (author), Bakker, A.F. (author), Moerman, I. (author), Groen, F.H. (author), Smit, M.K. (author)
journal article 1999
document
van der Weijde, J.O. (author), Smit, B. (author), Fritschi, M.. (author), van de Kamp, C.. (author), Vallery, H. (author)
The recently introduced twisted and coiled polymer muscle is an inexpensive and lightweight compliant actuator. Incorporation of themuscle in applications that rely on feedback creates the need for deflection and force sensing. In this paper, we explore a sensing principle that does not require any bulky or expensive additional hardware: Self...
journal article 2017
document
Spiekman, L.H. (author), Oei, Y.S. (author), Metaal, E.G. (author), Green, F.H. (author), Moerman, I. (author), Smit, M.K. (author)
journal article 1994
document
Smit, G.D.J. (author), Rogge, S. (author), Caro, J. (author), Klapwijk, T.M. (author)
journal article 2003
document
Tsekmes, I.A. (author), Morshuis, P.H.F. (author), Smit, J.J. (author), Kochetov, R. (author)
In this study, epoxy-cubic boron nitride composites are fabricated, and their dielectric response is investigated. They exhibit the same trend as epoxy composites reinforced with other filler types. Thus, at low filler concentrations, they exhibit a lower relative permittivity than neat epoxy. As the fill grade further increases, the relative...
journal article 2015
document
Smit, J.J. (author), Andritsch, T. (author), Chevtchenko, O.A. (author)
Assets in high voltage technology have to meet harsh service conditions over long lifetimes of 40 years or more. Due to environmental concerns, substitution of conventional insulating materials becomes a necessity. Because robustness and sustainability are serious requirements, only few new materials are really breaking through. At present some...
journal article 2012
document
Smit, G. (author), Plettenburg, D.H. (author)
The Delft Institute of Prosthetics and Orthotics has started a research program to develop an improved voluntary closing, body-powered hand prosthesis. Five commercially available voluntary closing terminal devices were mechanically tested: three hands [Hosmer APRL VC hand, Hosmer Soft VC Male hand, Otto Bock 8K24] and two hooks [Hosmer APRL VC...
journal article 2010
document
Bodega, R. (author), Morshuis, P.H.F. (author), Smit, J.J. (author)
journal article 2006
document
van Dam, C. (author), Spiekman, L.H. (author), van Ham, F.P.G.M. (author), Groen, F.H. (author), van der Tol, J.J.G.M. (author), Moerman, I. (author), Pascher, W.W. (author), Hamacher, M. (author), Heidrich, H. (author), Weinert, C.M. (author), Smit, M.K. (author)
journal article 1996
document
Caro, J. (author), Vink, I.D. (author), Smit, G.D.J. (author), Rogge, S. (author), Klapwijk, T.M. (author), Loo, R. (author), Caymax, M. (author)
journal article 2004
document
Chevtchenko, O. (author), Zuijderduin, R. (author), Smit, J. (author), Willen, D. (author), Lentge, H. (author), Thidemann, C. (author), Traeholt, C. (author)
Particulars of 6 km long HTS AC power cable for Amsterdam project are: a cable has to fit in an annulus of 160 mm, with only two cooling stations at the cable ends [1]. Application of existing solutions for HTS cables would result in excessively high coolant pressure drop in the cable, possibly affecting public acceptance of the project. In...
journal article 2012
document
Latkowski, S. (author), Hansel, A. (author), Bhattacharya, N. (author), De Vries, T. (author), Augustin, L. (author), Williams, K. (author), Smit, M. (author), Bente, E. (author)
journal article 2015
document
Henselmans, P.W.J. (author), Gottenbos, Stefan (author), Smit, G. (author), Breedveld, P. (author)
Follow-the-leader propagation allows for the insertion of flexible surgical instruments along curved paths, reducing the access required for natural orifice transluminal endoscopic surgery. Currently, the most promising follow-the-leader instruments use the alternating memory method containing two mechanical memory-banks for controlling the...
journal article 2017
document
Oliveira, Bruna R F (author), Smit, Martijn P J (author), Veld, Harry (author), van Paassen, L.A. (author), Rijnaarts, Huub H M (author), Grotenhuis, Tim C. (author)
Land subsidence in low-lying peatlands can be caused by shrinkage and organic matter oxidation. When these areas have networks of ditches and canals for drainage purposes, the sediments that accumulate in the waterways can be used to reverse the process of land subsidence. The objective of this study is to understand how dredged sediments can...
journal article 2018
Searched for:
(1 - 20 of 86)

Pages