Searched for: +
(21 - 40 of 522)

Pages

document
Wang, L. (author), Qin, Z. (author), Xiao, J. (author), Bauer, P. (author)
The critical short circuit ratio (CSCR), as an important metric for grid stability evaluation, is not clearly defined in the literature. Aimed at clarifying the misunderstandings, the paper compares the different CSCR definitions. Moreover, CSCR reduction-oriented design is studied for electric vehicle chargers. Simulations verify the analysis.
conference paper 2023
document
Yu, G. (author), Ye, P. (author), Grazian, F. (author), Dong, J. (author), Soeiro, Thiago B. (author), Bauer, P. (author)
The pursuit of battery charging technology for electric vehicle (EV) has led to extensive research on the inductive-based wireless power transfer (WPT) systems. In this paper, the compensation component (including coils) stresses will be studied in two commonly adopted compensation topologies, namely S-S and LCC-S compensations. Due to the peak...
conference paper 2023
document
Sinha, P. (author), Yadav, S. (author), Qin, Z. (author), Bauer, P. (author)
Series-connected MOSFETs with lower voltage ratings can be an alternative for single high-voltage switches. This paper compares two switch configurations for the soft-switched power converter topology targeted for a 1400V DC grid. The first configuration is a single switch rated at 1700V whereas the other is a series connected two MOSFETs rated...
conference paper 2023
document
Xiao, J. (author), Wang, L. (author), Qin, Z. (author), Bauer, P. (author)
This paper proposes a virtual impedance reshaping strategy to share active and harmonic power while promoting the PCC voltage quality. Moreover, the suggested method is resilient to cyber-attacks and immune to communication interruption and delay. Furthermore, it significantly reduces the communication burden. Experiments verify the...
conference paper 2023
document
Slaifstein, D.A. (author), Alpizar Castillo, J.J. (author), Menendez Agudin, A. (author), Ramirez Elizondo, L.M. (author), Chandra Mouli, G.R. (author), Bauer, P. (author)
In the context of building electrification the operation of distributed energy resources integrating multiple energy carriers poses a significant challenge. Such an operation calls for an energy management system that decides the set-points of the primary control layer in the best way possible. This is done by fulfilling user requirements,...
conference paper 2023
document
Molenaar, M. (author), Kardan Halvaei, F. (author), Shekhar, A. (author), Bauer, P. (author)
The reliability of semiconductor power devices can be studied by performing a thermal and power cycling test. In order to create the desired temperature cycles, there are four free variables to select during the power cycling test, namely the heating current, heating time, cooling time, and heatsink temperature. In this paper, the relation...
conference paper 2023
document
Bauer, Christine (author), Carterette, Ben (author), Ferro, Nicola (author), Fuhr, Norbert (author), Beel, Joeran (author), Breuer, Timo (author), Clarke, Charles L. A. (author), Dietz, Laura (author), Urbano, Julián (author)
This report documents the program and the outcomes of Dagstuhl Seminar 23031 "Frontiers of Information Access Experimentation for Research and Education", which brought together 38 participants from 12 countries. The seminar addressed technology-enhanced information access (information retrieval, recommender systems, natural language processing)...
journal article 2023
document
Mirzadarani, R. (author), Ghaffarian Niasar, M. (author), Li, Z. (author), Qin, Z. (author), Vaessen, P.T.M. (author), Bauer, P. (author), Van Lieshout, Lou (author)
Green hydrogen production uses renewable energies to energise the electrolysers for hydrogen production. The present paper compares possible solutions and configurations of a medium-frequency transformer (MFT) as part of a solid-state transformer (SST) in green hydrogen production applications. The single-phase and three-phase MFTs are compared...
conference paper 2023
document
Deshmukh, R.S. (author), Rituraj, G. (author), Lock, Niels (author), Vahedi, H (author), Shekhar, A. (author), Bauer, P. (author)
Power electronics converters (PEC) play a crucial role in interfacing renewable energy systems and electrolyzers to ensure a high production yield of green hydrogen. The design of such PEC is not straightforward due to the safety hazards of using multiple electrolyzer stacks and converter modules at industrial levels. Therefore, real-time...
conference paper 2023
document
Kardan Halvaei, F. (author), Shekhar, A. (author), Bauer, P. (author)
EV fast chargers are essential in addressing the concern of limited driving range for E-mobility applications. However, the load profile of a converter for fast charging involves a high-current pulse that can last for a few minutes to efficiently replenish the EV battery, which is followed by a cooldown period after the charging process is...
conference paper 2023
document
Zhu, G. (author), Dong, J. (author), Bauer, P. (author)
It is ideal for the wireless power transfer (WPT) systems to operate at the resonance state for better transmission performance. In practice, however, the parameters of the resonant circuits often deviate because of the capacitance drift and coil misalignment. To this end, this paper proposes a new parameter estimation method for the WPT systems...
conference paper 2023
document
Deshmukh, R.S. (author), Rituraj, G. (author), Vahedi, H (author), Shekhar, A. (author), Bauer, P. (author)
Electrolysis requires a high DC current at low voltage to produce hydrogen from water. Designing power converters for such a load requirement could be challenging while fulfilling the galvanic isolation needs. Therefore, prior knowledge of the electrolyzer's impact on the converter operation should be needed. In this context, this paper...
conference paper 2023
document
van der Sande, Robin (author), Deshmukh, R.S. (author), Shekhar, A. (author), Bauer, P. (author)
When operating a modular multilevel converter (MMC), a margin appears between the arm voltage and sum capacitor voltage corresponding to the power dependent ripple. This margin can be used to enhance the DC link voltage and increase the transfer capacity of an MMC-based distribution link while keeping the submodule (SM) stresses fixed....
conference paper 2023
document
Kardan Halvaei, F. (author), Shekhar, A. (author), Bauer, P. (author)
The load profile of the power converter in EV Fast charging applications involves a short high-current pulse for rapid charging of the EV battery leading to thermal cycles on the power electronic devices. These thermal cycles can cause thermo-mechanical fatigues, which consume the power devices’ lifetime. Also, different timescales and magnitude...
conference paper 2023
document
Wu, Y. (author), Qin, Z. (author), Soeiro, Thiago B. (author), Bauer, P. (author)
With the great emphasis from the international standard-setting community on the so-called supra-harmonics emissions (2-150 kHz), there are increasing research efforts in this noise level identification, measurement, standard setting and mitigation. The periodic variable switching frequency PWM method, which is known as VSFPWM, can reshape the...
conference paper 2023
document
Yu, Haoyuan (author), Zhang, Hanwen (author), Wang, Yanbo (author), Qin, Z. (author), Chen, Zhe (author), Bauer, P. (author)
This article investigates the stability of triple active bridge (TAB) converter with different types of loads. In this paper, port2 of TAB converter adopts voltage control to supply a constant power load (CPL), and port3 uses voltage control to supply a resistor or uses current control to supply a battery. Then, an extra element theorem-based ...
conference paper 2023
document
Yu, G. (author), Dong, J. (author), Soeiro, Thiago B. (author), Bauer, P. (author)
This paper introduces variable-frequency zero voltage switching (ZVS) modulation strategy for the four-switch buck+boost converter with one operating pattern for the inductor current, i.e., three-segment inductor current modulation control. The proposed modulation scheme guarantees a smooth transition from step-up to step-down or from step-down...
conference paper 2023
document
Alpizar Castillo, J.J. (author), Ramirez Elizondo, L.M. (author), Bauer, P. (author)
The energy transition requires electrical alternatives for domestic heating. Heat pumps are the most common alternatives to gas boilers. However, heat pumps consume a significant amount of electrical power. We simulated an 18-node low voltage network with five buildings with six apartments each to evaluate the effect of deploying heat pumps as...
conference paper 2023
document
Kouwerberg, Sang Jae (author), Alpizar Castillo, J.J. (author), Ramirez Elizondo, L.M. (author), Bauer, P. (author)
Batteries are one of the main tools to provide the flexibility distribution and transmission systems need due to their increasing dependence on weather conditions. However, environmental and economic factors pose a significant problem. New types of batteries that do not rely on rare earth metals and organic solvents but instead use water and...
conference paper 2023
document
Carmiggelt, J.J. (author), Bertelli, I. (author), Mulder, R.W. (author), Teepe, A. (author), Elyasi, Mehrdad (author), Simon, B.G. (author), Bauer, G.E. (author), Blanter, Y.M. (author), van der Sar, T. (author)
Quantum sensing has developed into a main branch of quantum science and technology. It aims at measuring physical quantities with high resolution, sensitivity, and dynamic range. Electron spins in diamond are powerful magnetic field sensors, but their sensitivity in the microwave regime is limited to a narrow band around their resonance...
journal article 2023
Searched for: +
(21 - 40 of 522)

Pages