Searched for: author%3A%22Aravind%2C+P.V.%22
(1 - 20 of 68)

Pages

document
Aravind, P.V. (author), Ouweltjes, J.P. (author), De Heer, E. (author), Woudstra, N. (author), Rierveld, B. (author)
journal article 2005
document
Aravind, P.V. (author), Ouweltjes, J.P. (author), Woudstra, N. (author), Rietveld, G. (author)
The impact of biomass-derived contaminants on solid-oxide fuel cells (SOFCs) with Ni/gadolinia-doped ceria (GDC) anodes was investigated using electrochemical impedance analysis. Measurements were carried out with symmetric test cells under a single-gas atmosphere. The impact of H2S, HCl, and naphthalene in the gas stream on the performance of...
journal article 2007
document
Qu, Z. (author), Aravind, P.V. (author), Ye, H. (author), Dekker, N.J.J. (author), Woudstra, N. (author), Verkooijen, A.H.M. (author)
journal article 2009
document
Aravind, P.V. (author), Ouweltjes, J.P. (author), Schoonman, J. (author)
Electrochemical impedance measurements were carried out on symmetrical nickel/gadolinia-doped ceria test cells. For H2, N2, and H2O mixtures, the diffusion length obtained based on the impedance measurements is on the order of centimeters. This high value of the diffusion length is attributed to the flow field in the reactor. It is suggested...
journal article 2009
document
Aravind, P.V. (author), Ouweltjes, J.P. (author), Schoonman, J. (author)
journal article 2009
document
Qu, Z. (author), Aravind, P.V. (author), Ye, H. (author), Dekker, N.J.J. (author), Woudstra, N. (author), Verkooijen, A.H.M. (author)
This paper presents a three-dimensional model of an anode-supported planar SOFC with corrugated bipolar plates serving as gas channels and current collector above the active area of the cell, based on the direct internal reforming reaction of methane and the electrochemical reaction of hydrogen. A co-flow system with gas mixture of methane,...
journal article 2009
document
Liu, M. (author), Millan, M.G. (author), Aravind, P.V. (author), Brandon, N. (author)
journal article 2011
document
Liu, M. (author), Millan-Agorio, M.G. (author), Aravind, P.V. (author), Brandon, N.P. (author)
This paper presents the influence of operation conditions including steam levels, current density and operating time on the performance of Solid Oxide Fuel Cells (SOFCs) fuelled by tar- containing biosyngas. The performance of SOFCs was evaluated by means of recording impedance spectra and polarization curves of the cells before and after tar...
journal article 2011
document
Patel, H.C. (author), Biradar, N. (author), Venkataraman, V. (author), Aravind, P.V. (author)
Pattern anodes can be used to localize reactions and study individual processes like charge transfer, adsorption, diffusion etc. Ceria and Nickel (Ni) pattern anodes were fabricated with the same dimensions with Triple phase boundary (TPB) lengths of 0.2707 m/cm2. Electrochemical Impedance Spectroscopy (EIS) of Ni anodes yielded results...
journal article 2013
document
Aravind, P.V. (author), Liu, M. (author), Fan, L. (author), Promes, E.J.O. (author), Giraldo, S.Y. (author), Woudstra, T. (author)
An overview of the research activities and on-going multiple projects at Delft University of Technology aimed at the development of Gasifier–Solid Oxide Fuel Cell (SOFC) based power plants are presented. Biosyngas generated in gasifiers consists of a mixture of carbon monoxide (CO), carbon dioxide (CO2), methane (CH4), hydrogen (H2), nitrogen ...
journal article 2013
document
Fan, L. (author), Pourquie, M.J.B.M. (author), Thattai, A. (author), Verkooijen, A.H.M. (author), Aravind, P.V. (author)
Mathematical modeling tools are useful for predicting the safe operation limits and efficiencies of SOFCs. For a particular SOFC design, variations in internal methane reforming kinetic parameters is expected to affect local gas compositions, local Nernst voltages, current densities and temperature profiles and in turn the safe operation limits...
journal article 2013
document
Patel, H.C. (author), Biradar, N. (author), Venkataraman, V. (author), Aravind, P.V. (author)
Ceria and nickel pattern anodes are prepared and tested in order to gain a fundamental insight into the electrochemical oxidation of hydrogen on either of these surfaces. It is found that ceria is highly active towards electrochemical oxidation of hydrogen with lower polarisation resistance because of the mixed ionic electronic conductivity of...
journal article 2014
document
Shamiri, A. (author), Chakrabarti, M.H. (author), Jahan, S. (author), Hussain, M.A. (author), Kaminsky, W. (author), Aravind, P.V. (author), Yehye, W.A. (author)
50 years ago, Karl Ziegler and Giulio Natta were awarded the Nobel Prize for their discovery of the catalytic polymerization of ethylene and propylene using titanium compounds and aluminum-alkyls as co-catalysts. Polyolefins have grown to become one of the biggest of all produced polymers. New metallocene/methylaluminoxane (MAO) catalysts open...
journal article 2014
document
Thallam Thattai, A. (author), Wittebrood, B.J. (author), Woudstra, T. (author), Geerlings, J.J.C. (author), Aravind, P.V. (author)
Flexibility in natural gas combined cycle power plants (NGCC) with pre-combustion CO2 capture could be introduced with co-production of hydrogen and subsequent hydrogen storage with metal hydrides (MH). The current work presents a thermodynamic analysis and comparison between steady state ASPEN Plus models of a reference case NGCC plant with no...
journal article 2014
document
Fernandes, A.A. (author), Woudstra, T. (author), van Wijk, A.J.M. (author), Verhoef, L.A. (author), Aravind, P.V. (author)
Delft University of Technology, under its "Green Village" programme, has an initiative to build a power plant (car parking lot) based on the fuel cells used in vehicles for motive power. It is a trigeneration system capable of producing electricity, heat, and hydrogen. It comprises three main zones: a hydrogen production zone, a parking zone,...
journal article 2016
document
Sturm, G.S.J. (author), Navarrete Muñoz, A. (author), Aravind, P.V. (author), Stefanidis, G. (author)
Gasification technology may combine waste treatment with energy generation. Conventional gasification processes are bulky and inflexible. By using an external energy source, in the form of microwave-generated plasma, equipment size may be reduced and flexibility as regards to the feed composition may be increased. This type of gasification...
journal article 2016
document
van Biert, L. (author), Godjevac, M. (author), Visser, K. (author), Aravind, P.V. (author)
Progressing limits on pollutant emissions oblige ship owners to reduce the environmental impact of their operations. Fuel cells may provide a suitable solution, since they are fuel efficient while they emit few hazardous compounds. Various choices can be made with regard to the type of fuel cell system and logistic fuel, and it is unclear...
journal article 2016
document
Thallam Thattai, A. (author), Oldenbroek, V.D.W.M. (author), Schoenmakers, L (author), Woudstra, T. (author), Aravind, P.V. (author)
journal article 2016
document
Tabish, A.N. (author), Patel, H.C. (author), Aravind, P.V. (author)
Fuel flexibility of solid oxide fuel cells enables the use of low cost and practical fuels like syngas. Understanding of the oxidation kinetics with syngas is essential for proper selection of anode material and its design optimization. Using nickel and ceria pattern anodes, we study the electrochemical oxidation of syngas in both dry and wet...
journal article 2017
document
Cavalli, A. (author), Kunze, M. (author), Aravind, P.V. (author)
conference paper 2017
Searched for: author%3A%22Aravind%2C+P.V.%22
(1 - 20 of 68)

Pages