Nonequilibrium interpretation of DC properties of NbN superconducting hot electron bolometers

We present a physically consistent interpretation of the dc electrical properties of niobiumnitride (NbN)-based superconducting hot-electron bolometer mixers, using concepts of nonequilibrium superconductivity. Through this, we clarify what physical information can be extracted from the resistive transition and the dc current-voltage...

Antenna-coupled 30 THz hot electron bolometer mixers

We report on design and characterization of a superconducting Hot Electron Bolometer Mixer integrated with a logarithmic spiral antenna for mid-IR range observations. The antenna parameters have been adjusted to achieve the ultimate performance at 10 ?m (30 THz) range where O3, NH3, CO2, CH4, N2O, …. lines in the Earth’s atmosphere, in planetary...

Coherent flux tunneling through NbN nanowires

We demonstrate evidence of coherent magnetic flux tunneling through superconducting nanowires patterned in a thin highly disordered NbN film. The phenomenon is revealed as a superposition of flux states in a fully metallic superconducting loop with the nanowire acting as an effective tunnel barrier for the magnetic flux, and reproducibly...

Photothermoelectric response in asymmetric carbon nanotube devices exposed to sub-terahertz radiation

We report on the voltage response of carbon nanotube devices to sub-terahertz (THz) radiation. The devices contain carbon nanotubes (CNTs), which are over their length partially suspended and partially Van der Waals bonded to a SiO2 substrate, causing a difference in thermal contact. We observe a DC voltage upon exposure to 140?GHz radiation....

Monocrystalline NbN nanofilms on a 3C-SiC/Si substrate

The authors have realized NbN (100) nanofilms on a 3C-SiC (100)/Si(100) substrate by dc reactive magnetron sputtering at 800?°C. High-resolution transmission electron microscopy (HRTEM) is used to characterize the films, showing a monocrystalline structure and confirming epitaxial growth on the 3C-SiC layer. A film ranging in thickness from 3.4...

Influence of the direct response on the heterodyne sensitivity of hot electron bolometer mixers

We present a detailed experimental study of the direct detection effect in a small volume (0.15??m×1??m×3.5?nm) quasioptical NbN phonon cooled hot electron bolometer mixer at 673?GHz. We find that the small signal noise temperature, relevant for an astronomical observation, is 20% lower than the noise temperature obtained using 300 and 77?K...

Stability of heterodyne terahertz receivers

In this paper we discuss the stability of heterodyne terahertz receivers based on small volume NbN phonon cooled hot electron bolometers (HEBs). The stability of these receivers can be broken down in two parts: the intrinsic stability of the HEB mixer and the stability of the local oscillator (LO) signal injection scheme. Measurements show that...

Direct detection effect in small volume hot electron bolometer mixers

We measure the direct detection effect in a small volume (0.15??m×1??m×3.5?nm) quasioptical NbN phonon cooled hot electron bolometer mixer at 1.6?THz. We find that the small signal sensitivity of the receiver is underestimated by 35% due to the direct detection effect and that the optimal operating point is shifted to higher bias voltages when...

Doubling of sensitivity and bandwidth in phonon cooled hot electron bolometer mixers

NbN hot electron bolometer (HEB) mixers are at this moment the best heterodyne detectors for frequencies above 1 THz. However, the fabrication procedure of these devices is such that the quality of the interface between the NbN superconducting film and the contact structure is not under good control. This results in a contact resistance between...

Doubling of sensitivity and bandwidth in phonon cooled hot electron bolometer mixers

We demonstrate that the performance of NbN lattice cooled hot electron bolometer mixers depends strongly on the interface quality between the bolometer and the contact structure. We show experimentally that both the receiver noise temperature and the gain bandwidth can be improved by more than a factor of 2 by cleaning the interface and adding...