Searched for: collection%253Air
(1 - 20 of 54)

Pages

document
Evers, L.G. (author), Brown, D. (author), Heaney, K.D. (author), Assink, J.D. (author), Smets, P.S.M. (author), Snellen, M. (author)
Atmospheric low-frequency sound, i.e., infrasound, from underwater events has not been considered thus far, due to the high impedance contrast of the water-air interface making it almost fully reflective. Here we report for the first time on atmospheric infrasound from a large underwater earthquake (Mw 8.1) near the Macquarie Ridge, which was...
journal article 2014
document
Ruigrok, E.N. (author)
Seismology is the study of the vibration of the Earth. Seismologists pay much attention to the main source of Earth vibration: earthquakes. But also other seismic sources, like mining blasts, ocean storms and windmills, are studied. All these sources induce seismic waves, which can eventually be recorded as ground vibrations. These seismic...
doctoral thesis 2012
document
Schakel, M.D. (author), Smeulders, D.M.J. (author), Slob, E.C. (author), Heller, H.K.J. (author)
Understanding the seismoelectric interface response is important for developing seismoelectric field methods for oil exploration and environmental/engineering geophysics. The existing seismoelectric theory has never been validated systematically by controlled experiments. We have designed and developed an experimental setup in which acoustic-to...
journal article 2011
document
Van der Neut, J.R. (author), Thorbecke, J.W. (author), Mehta, K. (author), Slob, E.C. (author), Wapenaar, C.P.A. (author)
Various researchers have shown that accurate redatuming of controlled seismic sources to downhole receiver locations can be achieved without requiring a velocity model. By placing receivers in a horizontal or deviated well and turning them into virtual sources, accurate images can be obtained even below a complex near-subsurface. Examples...
journal article 2011
document
Mahdad, A. (author), Doulgeris, P. (author), Blacquiere, G. (author)
Seismic acquisition is a trade-off between economy and quality. In conventional acquisition the time intervals between successive records are large enough to avoid interference in time. To obtain an efficient survey, the spatial source sampling is therefore often (too) large. However, in blending, or simultaneous acquisition, temporal overlap...
journal article 2011
document
Schakel, M.D. (author), Smeulders, D.M.J. (author), Slob, E.C. (author), Heller, H.K.J. (author)
A full-waveform seismoelectric numerical model incorporating the directivity pattern of a pressure source is developed. This model provides predictions of coseismic electric fields and the electromagnetic waves that originate from a fluid/porous-medium interface. An experimental setup in which coseismic electric fields and interface responses...
journal article 2011
document
Gouedard, P. (author), Roux, P. (author), Campillo, M. (author), Verdel, A.R. (author), Yao, H. (author), Van der Hilst, R.D. (author)
We use seismic prospecting data on a 40 × 40 regular grid of sources and receivers deployed on a 1 km × 1 km area to assess the feasibility and advantages of velocity analysis of the shallow subsurface by means of surface-wave tomography with Green's functions estimated from crosscorrelation. In a first application we measure Rayleigh-wave...
journal article 2011
document
Trani, M. (author), Arts, R. (author), Leeuwenburgh, O. (author), Brouwer, J. (author)
A reliable estimate of reservoir pressure and fluid saturation changes from time-lapse seismic data is difficult to obtain. Existing methods generally suffer from leakage between the estimated parameters. We propose a new method using different combinations of time-lapse seismic attributes based on four equations: two expressing changes in...
journal article 2011
document
Minato, S. (author), Matsuoka, T. (author), Tsuji, T. (author), Draganov, D.S. (author), Hunziker, J.W. (author), Wapenaar, C.P.A. (author)
Crosswell reflection method is a high-resolution seismic imaging method that uses recordings between boreholes. The need for downhole sources is a restrictive factor in its application, for example, to time-lapse surveys. An alternative is to use surface sources in combination with seismic interferometry. Seismic interferometry (SI) could...
journal article 2011
document
Verschuur, D.J. (author), Berkhout, A.J. (author)
This paper focuses on the concept of using blended data and multiple scattering directly in the migration process, meaning that the blended input data for the proposed migration algorithm includes blended surface-related multiples. It also means that both primary and multiple scattering contribute to the seismic image of the subsurface....
journal article 2011
document
El Allouche, N. (author), Drijkoningen, G.G. (author), Versteeg, W. (author), Ghose, R. (author)
Seismic waves converted from compressional to shear mode in the shallow subsurface can be useful not only for obtaining shear-wave velocity information but also for improved processing of deeper reflection data. These waves generated at deep seas have been used successfully in hydrocarbon exploration; however, acquisition of good-quality...
journal article 2011
document
El Allouche, N. (author), Drijkoningen, G.G. (author), Van der Neut, J.R. (author)
A widespread use of converted waves for shallow marine applications is hampered by spatial aliasing and field efficiency. Their short wavelengths require dense spatial sampling which often needs to be achieved by receivers deployed on the seabed. We adopted a new methodology where the dense spatial sampling is achieved in the common-receiver...
journal article 2010
document
Tetyukhina, D. (author), Van Vliet, L.J. (author), Luthi, S.M. (author), Wapenaar, C.P.A. (author)
Fluvio-deltaic sedimentary systems are of great interest for explorationists because they can form prolific hydrocarbon plays. However, they are also among the most complex and heterogeneous ones encountered in the subsurface, and potential reservoir units are often close to or below seismic resolution. For seismic inversion, it is therefore...
journal article 2010
document
Ruigrok, E.N. (author), Campman, X. (author), Draganov, D.S. (author), Wapenaar, K. (author)
In recent years, there has been an increase in the deployment of relatively dense arrays of seismic stations. The availability of spatially densely sampled global and regional seismic data has stimulated the adoption of industry-style imaging algorithms applied to converted- and scattered-wave energy from distant earthquakes, leading to...
journal article 2010
document
Wapenaar, C.P.A. (author), Draganov, D.S. (author), Snieder, R. (author), Campman, X. (author), Verdel, A. (author)
Seismic interferometry involves the crosscorrelation of responses at different receivers to obtain the Green's function between these receivers. For the simple situation of an impulsive plane wave propagating along the x-axis, the crosscorrelation of the responses at two receivers along the x-axis gives the Green's function of the direct wave...
journal article 2010
document
Wapenaar, C.P.A. (author), Slob, E.C. (author), Snieder, R. (author), Curtis, A. (author)
In the 1990s, the method of time-reversed acoustics was developed. This method exploits the fact that the acoustic wave equation for a lossless medium is invariant for time reversal. When ultrasonic responses recorded by piezoelectric transducers are reversed in time and fed simultaneously as source signals to the transducers, they focus at the...
journal article 2010
document
Dragoset, B. (author), Verschuur, D.J. (author), Moore, I. (author), Bisley, R. (author)
Surface-related multiple elimination (SRME) is an algorithm that predicts all surface multiples by a convolutional process applied to seismic field data. Only minimal preprocessing is required. Once predicted, the multiples are removed from the data by adaptive subtraction. Unlike other methods of multiple attenuation, SRME does not rely on...
journal article 2010
document
Van Groenestijn, G.J.A. (author), Verschuur, D.J. (author)
For passive seismic data, surface multiples are used to obtain an estimate of the subsurface responses, usually by a crosscorrelation process. This crosscorrelation process relies on the assumption that the surface has been uniformly illuminated by subsurface sources in terms of incident angles and strengths. If this is not the case, the...
journal article 2010
document
Wapenaar, C.P.A. (author), Slob, E.C. (author), Snieder, R. (author)
We have analyzed the far-field approximation of the Green's function representation for seismic interferometry. By writing each of the Green's functions involved in the correlation process as a superposition of a direct wave and a scattered wave, the Green's function representation is rewritten as a superposition of four terms. When the...
journal article 2010
document
Abubakar, A. (author), Hu, W. (author), Habashy, T.M. (author), Van den Berg, P.M. (author)
We have applied the finite-difference contrast-source inversion (FDCSI) method to seismic full-waveform inversion problems. The FDCSI method is an iterative nonlinear inversion algorithm. However, unlike the nonlinear conjugate gradient method and the Gauss-Newton method, FDCSI does not solve any full forward problem explicitly in each iterative...
journal article 2009
Searched for: collection%253Air
(1 - 20 of 54)

Pages