Searched for: contributor:"Sietsma, J. (mentor)"
(1 - 20 of 38)

Pages

document
Kokkirala, Sahith (author)
Carburized steel grades are widely used in applications where high hardness at the surface is required in combination with good core toughness as well as high fatigue resistance. The process of carburizing lower to medium carbon steel can generally provide this combination of properties and has been practised for several decades. Such steel is...
master thesis 2020
document
Hou, J. (author)
Interstitial free (IF) steel is widely used in the automobile industry for car outer panel because of its good formability. Recently automotive industry pays more attention to paint appearance, and therefore demands good waviness performance of sheet steels after stamping. This thesis aims to study the factors in the microstructure that...
master thesis 2017
document
Wu, X. (author)
With a combination of high strength and good formability, dual-phase steels have gained much interest in the automobile industry. The final microstructure, which leads to mechanical properties of the product, is strongly dependent on the processing of the steel. Apart from hot-rolling and cold-rolling, the parameters during continuous annealing...
master thesis 2016
document
Castillo, D.E. (author)
master thesis 2013
document
Pattabhiraman, H. (author)
The mechanical properties of steel are influenced by its microstructure, which is obtained as a result of processing conditions. It is, thus, important to study the effect of these conditions on the microstructure. A three dimensional microstructure model, based on a cellular automata (CA) model, was previously developed. The model is capable of...
master thesis 2013
document
Nienhuis, J. (author)
Samples from two bronze Geistingen axes, one from Nijmegen and one from Tongeren, are examined and analysed in order to answer the question ‘How are they produced?’. It is concluded that both axes do not have the same composition: the Nijmegen axe is identified as a binary copper-tin bronze, while the Tongeren axe is regarded as a ternary copper...
master thesis 2009
document
Citrawati, F. (author)
master thesis 2008
document
Nguyen Minh, Tuan (author)
master thesis 2008
document
Sharma, H. (author)
master thesis 2008
document
Volkers, R. (author)
master thesis 2008
document
Van der Zijden, A.C.P. (author)
master thesis 2007
document
Bergwerf, R. (author)
This master thesis deals with the research to the effects of severe plastic deformation on the development of the microstructure and the mechanical properties of three low-alloyed high-carbon steels. The steels investigated include a hypo-eutectoid, an eutectoid and a hyper-eutectoid steel containing 0.61, 0.81 and 1.22 weight-percent carbon....
master thesis 2007
document
Leever, Sylvia (author)
master thesis 2005
document
Janssen, R. (author)
master thesis 2004
document
Geuzebroek, S. (author)
master thesis 2004
document
Bos, C. (author)
master thesis 2002
document
Moreno Exebio, J.J. (author)
master thesis 2002
document
Levi, N. (author)
master thesis 2001
document
Fu, Y. (author)
master thesis 1998
document
Van Aken, B. (author)
master thesis 1997
Searched for: contributor:"Sietsma, J. (mentor)"
(1 - 20 of 38)

Pages