Searched for: department%3A%22MSE%22
(1 - 8 of 8)
document
Kurniadi Isnu, I.I. (author)
A novel method to encapsulate MoSi2B healing particles was explored via in situ shell formation in yttria-stabilised zirconia thermal barrier coatings (YSZ-BCs). The shell formation was analysed for MoSi2B healing particles alloyed with 2, 6 and 12 wt% Al. According to oxidation kinetics study at 1100˚C using thermogravimetry, MoSi2B-12 wt% Al...
master thesis 2016
document
Wu, X. (author)
With a combination of high strength and good formability, dual-phase steels have gained much interest in the automobile industry. The final microstructure, which leads to mechanical properties of the product, is strongly dependent on the processing of the steel. Apart from hot-rolling and cold-rolling, the parameters during continuous annealing...
master thesis 2016
document
Deminska, P.O. (author)
To reduce the cycle times required for grit blasting prior to the application of an epoxy coating on the pipelay vessel an alternative method for the surface preparation is required. The method should be effective in material removal and ensure perfect adhesion of the organic coating to the carbon steel surface. In this study, a well-established...
master thesis 2016
document
Slachter, E.G. (author)
The Circumferentially Notched Tension (CNT) specimen is a potential candidate for determining the fracture toughness of highly constrained cracks, theoretically approaching plane strain conditions, even for small test specimen dimensions. This research aims to experimentally evaluate the use of the CNT test specimen geometry to fracture...
master thesis 2016
document
Van Bruggen, E.P.A. (author)
Background: The growth of the global population in combination with technological development results in the need to improve the living conditions. This led to a significant and unsustainable increase in production of products. The unstable increase is especially the case for plastics, which have an annual worldwide production of over 288...
master thesis 2015
document
Santillana, M.B. (author)
Nowadays a vast majority of the steel produced worldwide is via the continuous casting process route because this is the most low-cost, efficient and high quality method to mass produce metal products in a variety of sizes and shapes. Most of the continuous casters are the initial manufacturing step of a product which is very close to the final...
doctoral thesis 2013
document
Zhang, L. (author)
The research in ultrasonic processing for metallurgical application shows a promising influence on improving casting properties of aluminium alloys. The principle of ultrasonic processing is introduction of acoustic waves with a frequency higher than 17 kHz into liquid metal. Several promising beneficial effects caused by ultrasonic processing...
doctoral thesis 2013
document
Jongenburger, P. (author), Zuithoff, A.J. (author), Druyvesteyn, M.J. (author), Burgers, W.G. (author)
Beschrijving van het in 1961 gereed gekomen nieuwe gebouw voor Metaalkunde van de Technische Hogeschool Delft, op de hoek Jaffalaan / Rotterdamseweg te Delft. Het werd geopend op 4 oktober 1961. Het ontwerp is van het architectenbureau Van den Broek en Bakema. In het begin van de jaren 2000 werd het gesloopt. In het boekje ontbreekt helaas een...
book 1961
Searched for: department%3A%22MSE%22
(1 - 8 of 8)