Recycling of Aluminosilicate-Based Solid Wastes through Alkali-Activation: Preparation, Characterization, and Challenges

Recycling aluminosilicate-based solid wastes is imperative to realize the sustainable development of constructions. By using alkali activation technology, aluminosilicate-based solid wastes, such as furnace slag, fly ash, red mud, and most of the bio-ashes, can be turned into alternative binder materials to Portland cement to reduce the carbon...

Effect of rice straw powder on properties of one-part alkali-activated slag

One-part alkali-activated slag (AAS) as a binder material has a promising application in the construction industry. The properties of one-part AAS incorporating agricultural wastes have been seldom studied. In this paper, the fresh and hardened properties of one-part AAS with the addition of rice straw powder (RSP) were investigated. The...

A comparison between alkali-activated slag/fly ash binders prepared with natural seawater and deionized water

In this research, the effects of natural seawater (SW) on the properties of alkali-activated slag/fly ash (AASF) are studied. AASF prepared with deionized water is set as the reference mixture. The results showed that the use of natural SW resulted in a prolonged setting time and lower heat release, but no obvious impact on the flowability of...

Strain hardening behaviour of PVA fibre reinforced geopolymer composites

Strain hardening geopolymer composites (SHGC) as a tailored group of fibre reinforced geopolymer composites are featured by large tensile strain capacity with multiple micro-cracks. This paper experimentally investigates the strain hardening behaviour of SHGC in terms of flexural stress-deflection response, failure mode and cracking, flexural...

Strength and microstructure of alkali-activated phosphorous slag binder: Effects of activator type/dosage and phosphorous slag chemical composition

In this paper, the influence of sodium hydroxide and water glass of various modulus, as activators, on the compressive strength, microstructure and hydration products of two alkali-activated phosphorous slag (AAPS) with different chemical composition were studied. Water glass activation shows relatively higher later compressive strength when the...

Effect of reactive aggregate on the early age reaction of water-glass activated slag/fly ash mortars

Alkali activated materials (AAMs) have received worldwide attention due to its lower embodied energy and environmental impact than that of traditional cementitious materials. However, the activators with high alkalinity may raise the risk of alkali silica reaction (ASR) induced deterioration when reactive aggregates are used, which thereby...

Experimental comparisons between one-part and normal (two-part) alkali-activated slag binders

One-part alkali-activated slag (AAS) binders are more promising in large-scale constructions because one-part mixing procedure is safer and easier to handle compared to normal two-part method. Thus, this study aims at investigating different properties of one-part AAS binders and control samples prepared using the two-part method. Experimental...