Searched for: subject%3A%22Band%255C-pass%255C+filter%22
(1 - 8 of 8)
document
Montazerolghaem, M.A. (author), de Vreede, L.C.N. (author), Babaie, M. (author)
By introducing three different techniques, this article, for the first time, presents a wideband highly linear receiver (RX) capable of handling blocking scenarios in fifth-generation (5G) microcell base station applications. First, a parallel preselect filter is introduced to satisfy the base station co-location blocking requirements. Next,...
journal article 2023
document
Mohan, M.A. (author), Kaczmarek, M.B. (author), Hassan HosseinNia, S. (author)
Active vibration control (AVC) is crucial for the structural integrity, precision, and speed of industrial machines. Despite advancements in nonlinear control techniques, most AVC techniques predominantly employ linear feedback control due to their simplicity and ability to be designed in the frequency domain. In this paper, we introduce a reset...
conference paper 2022
document
Pascual Laguna, A. (author), Karatsu, K. (author), Thoen, David (author), Murugesan, Vignesh (author), Buijtendorp, B.T. (author), Endo, A. (author), Baselmans, J.J.A. (author)
A superconducting microstrip half-wavelength resonator is proposed as a suitable band-pass filter for broadband moderate spectral resolution spectroscopy for terahertz (THz) astronomy. The proposed filter geometry has a free spectral range of an octave of bandwidth without introducing spurious resonances, reaches a high coupling efficiency in...
journal article 2021
document
Wu, J. (author), Mor, A. R. (author), van Nes, P.V.M. (author), Smit, J.J. (author)
A partial discharge (PD) measuring system has been deployed in order to identify and measure PD in a high voltage (HV) cable joint under impulse and superimposed voltages under laboratory conditions. The challenge is to enable the detection of PD during the impulse conditions. The method of measurement has been investigated by introducing an...
journal article 2019
document
Zjajo, Amir (author), van Leuken, T.G.R.M. (author)
In this paper, we present a neural recording interface circuit for biomedical implantable devices, which includes low-noise signal amplification, band-pass filtering, and current-mode successive approximation A/D signal conversion. The integrated interface circuit is realized in a 65 nm CMOS technology, and consumes less than 2.1 μW/channel of...
conference paper 2016
document
Ngamkham, W. (author)
Cochlear Implants (CIs) are prosthetic devices that restore hearing in profoundly deaf patients by bypassing the damaged parts of the inner ear and directly stimulating the remaining auditory nerve fibers in the cochlea with electrical pulses. This thesis describs the electronic circuit design of various modules for application in CIs in order...
doctoral thesis 2015
document
Tohidian, M. (author)
In a radio-frequency (RF) system-on-chip (SoC), a digital baseband/application processor, which occupies most of the silicon area, determines the SoC fabrication process technology and voltage supply. The rest of the circuitry, including RF front-end and frequency synthesizer, must then adopt the chosen process technology, i.e., presently low...
doctoral thesis 2015
document
Baselmans, J.J.A. (author), Baryshev, A. (author), Reker, S.F. (author), Hajenius, M. (author), Gao, J.R. (author), Klapwijk, T.M. (author), Vachtomin, Y. (author), Maslennikov, S. (author), Antipov, S. (author), Voronov, B. (author), Gol'tsman, G. (author)
We measure the direct detection effect in a small volume (0.15??m×1??m×3.5?nm) quasioptical NbN phonon cooled hot electron bolometer mixer at 1.6?THz. We find that the small signal sensitivity of the receiver is underestimated by 35% due to the direct detection effect and that the optimal operating point is shifted to higher bias voltages when...
journal article 2005
Searched for: subject%3A%22Band%255C-pass%255C+filter%22
(1 - 8 of 8)