Point spread function of photon-counting detectors under pile-up conditions: a proposed framework

X-ray detectors with photon-counting capabilities promise to revolutionise medical imaging. For an efficient comparison of detectors of various materials and with different setup choices, reliable detector performance measures are needed. The detector point spread function (PSF) is a commonly used measure, which describes the spatial response...

Physics and technology of time-of-flight PET detectors

The imaging performance of clinical positron emission tomography (PET) systems has evolved impressively during the last ∼15 years. A main driver of these improvements has been the introduction of time-of-flight (TOF) detectors with high spatial resolution and detection efficiency, initially based on photomultiplier tubes, later silicon...

Efficient Single-Photon Detection with 7.7 ps Time Resolution for Photon-Correlation Measurements

A broad range of scientific and industrial disciplines require precise optical measurements at very low light levels. Single-photon detectors combining high efficiency and high time resolution are pivotal in such experiments. By using relatively thick films of NbTiN (8-11 nm) and improving the pattern fidelity of the nanostructure of the...

An Approach for Optimizing Prompt Gamma Photon-Based Range Estimation in Proton Therapy Using Cramér-Rao Theory

Various methods for in vivo range estimation during proton therapy based on the measurement of prompt gamma (PG) photons have been proposed. However, optimizing the method of detection by trial-and-error is a tedious endeavor. Here, we investigate the feasibility of using the Cramér-Rao lower bound (CRLB) to more quickly arrive at an optimum...

Optimization of the signal-to-background ratio in prompt gamma imaging using energy- and shifting time-of-flight discrimination: experiments with a scanning parallel-slit collimator

Much attention is currently being paid to imaging prompt gamma (PG) rays for in vivo proton range monitoring in proton therapy. PG imaging using a collimator is affected by neutron-related background. We study the effectiveness of background reduction experimentally, using a scanning parallel-slit PG collimator as a simplified model of a...

Sub-3 mm, near-200 ps TOF/DOI-PET imaging with monolithic scintillator detectors in a 70 cm diameter tomographic setup

Recently, a monolithic scintillator detector for time-of-flight (TOF)/depth-of-interaction (DOI) positron emission tomography (PET) was developed. It has a detector spatial resolution of ∼1.7 mm full-width-at-half-maximum (FWHM), a coincidence resolving time (CRT) of ∼215 ps FWHM, and ∼4.7 mm FWHM DOI resolution. Here, we demonstrate, for the...

Improved image quality using monolithic scintillator detectors with dual-sided readout in a whole-body TOF-PET ring: A simulation study

We have recently built and characterized the performance of a monolithic scintillator detector based on a 32 mm × 32 mm × 22 mm LYSO:Ce crystal read out by digital silicon photomultiplier (dSiPM) arrays coupled to the crystal front and back surfaces in a dual-sided readout (DSR) configuration. The detector spatial resolution appeared to be...

A comprehensive characterization of the time resolution of the Philips Digital Photon Counter

Photodetectors with excellent time resolution are becoming increasingly important in many applications in medicine, high energy- and nuclear physics applications, biology, and material science. Silicon photomultipliers (SiPM) are a novel class of solid-state photodetectors with good timing properties. While the time resolution of analog SiPMs...

Towards monolithic scintillator based TOF-PET systems: Practical methods for detector calibration and operation

Gamma-ray detectors based on thick monolithic scintillator crystals can achieve spatial resolutions <2 mm full-width-at-half-maximum (FWHM) and coincidence resolving times (CRTs) better than 200 ps FWHM. Moreover, they provide high sensitivity and depth-of-interaction (DOI) information. While these are excellent characteristics for...

A 32 mm × 32 mm × 22 mm monolithic LYSO: Ce detector with dual-sided digital photon counter readout for ultrahigh-performance TOF-PET and TOF-PET/MRI

New applications for positron emission tomography (PET) and combined PET/magnetic resonance imaging (MRI) are currently emerging, for example in the fields of neurological, breast, and pediatric imaging. Such applications require improved image quality, reduced dose, shorter scanning times, and more precise quantification. This can be...

Time-based position estimation in monolithic scintillator detectors

Gamma-ray detectors based on bright monolithic scintillation crystals coupled to pixelated photodetectors are currently being considered for several applications in the medical imaging field. In a typical monolithic detector, both the light intensity and the time of arrival of the earliest scintillation photons can be recorded by each of the...

Improving the Time Resolution of TOF-PET Detectors by Double-Sided Readout

State-of-the-art scintillation detectors for time-of-flight positron emission tomography (TOF-PET) typically employ scintillation crystals with a high aspect ratio (e.g. 4 ×4 ×22 mm3) read out on one of the small crystal surfaces. This single-sided readout (SSR) geometry may be unfavorable in terms of the coincidence resolving time (CRT) that...

A Comprehensive Model of the Response of Silicon Photomultipliers

The response of a silicon photomultiplier (SiPM) to optical signals is inherently nonproportional due to saturation, afterpulsing, and crosstalk. Existing models of the SiPM response do not account for all of these effects, and therefore, these models are not sufficiently accurate for many applications. In this work, a comprehensive model of the...

Signal to Noise Ratio of APD-Based Monolithic Scintillator Detectors for High Resolution PET