Noise temperature and beam pattern of an NbN hot electron bolometer mixer at 5.25 THz

We report the measured sensitivities of a superconducting NbN hot electron bolometer (HEB) heterodyne receiver at 5.25 THz. Terahertz (THz) radiation is quasioptically coupled to a HEB mixer with a lens and a spiral antenna. Using a measurement setup with black body calibration sources and a beam splitter in vacuo, and an antireflection coated...

Quantum noise in a terahertz hot electron bolometer mixer

We have measured the noise temperature of a single, sensitive superconducting NbN hot electron bolometer (HEB) mixer in a frequency range from 1.6 to 5.3 THz, using a setup with all the key components in vacuum. By analyzing the measured receiver noise temperature using a quantum noise (QN) model for HEB mixers, we confirm the effect of QN. The...

Low noise NbN hot electron bolometer mixer at 4.3?THz

We have studied the sensitivity of a superconducting NbN hot electron bolometer mixer integrated with a spiral antenna at 4.3?THz. Using hot/cold blackbody loads and a beam splitter all in vacuum, we measured a double sideband receiver noise temperature of 1300?K at the optimum local oscillator (LO) power of 330?nW, which is about 12 times the...

IF impedance and mixer gain of NbN hot electron bolometers

The intermediate frequency (IF) characteristics, the frequency dependent IF impedance, and the mixer conversion gain of a small area hot electron bolometer (HEB) have been measured and modeled. The device used is a twin slot antenna coupled NbN HEB mixer with a bridge area of 1×0.15??m2, and a critical temperature of 8.3?K. In the experiment the...

Full characterization and analysis of a terahertz heterodyne receiver based on a NbN hot electron bolometer

We present a complete experimental characterization of a quasioptical twin-slot antenna coupled small area (1.0×0.15??m2) NbN hot electron bolometer (HEB) mixer compatible with currently available solid state tunable local oscillator (LO) sources. The required LO power absorbed in the HEB is analyzed in detail and equals only 25?nW. Due to the...

Stability of heterodyne terahertz receivers

In this paper we discuss the stability of heterodyne terahertz receivers based on small volume NbN phonon cooled hot electron bolometers (HEBs). The stability of these receivers can be broken down in two parts: the intrinsic stability of the HEB mixer and the stability of the local oscillator (LO) signal injection scheme. Measurements show that...

Current-induced vortex unbinding in bolometer mixers

We present a description of the current-voltage characteristics of hot electron bolometers in terms of the current-dependent intrinsic resistive transition of NbN films. We find that, by including this current dependence, we can correctly predict the complete current-voltage characteristics, showing excellent agreement with measurements for both...

Terahertz heterodyne receiver based on a quantum cascade laser and a superconducting bolometer

We report the first demonstration of an all solid-state heterodyne receiver that can be used for high-resolution spectroscopy above 2?THz suitable for space-based observatories. The receiver uses a NbN superconducting hot-electron bolometer as mixer and a quantum cascade laser operating at 2.8?THz as local oscillator. We measure a double...

Direct detection effect in small volume hot electron bolometer mixers

We measure the direct detection effect in a small volume (0.15??m×1??m×3.5?nm) quasioptical NbN phonon cooled hot electron bolometer mixer at 1.6?THz. We find that the small signal sensitivity of the receiver is underestimated by 35% due to the direct detection effect and that the optimal operating point is shifted to higher bias voltages when...

Doubling of sensitivity and bandwidth in phonon cooled hot electron bolometer mixers

We demonstrate that the performance of NbN lattice cooled hot electron bolometer mixers depends strongly on the interface quality between the bolometer and the contact structure. We show experimentally that both the receiver noise temperature and the gain bandwidth can be improved by more than a factor of 2 by cleaning the interface and adding...