Combining asynchronous microphone array measurements for enhanced acoustic imaging and volumetric source mapping

This paper explores the advantages of combining asynchronous microphone array measurements for acoustic source mapping in two and three–dimensional applications. Four different approaches are considered, three consisting of the combination of the source maps (arithmetic mean, geometric mean, and minimum value), and a fourth one obtained by...

Evaluation of the effect of microphone cavity geometries on acoustic imaging in wind tunnels

Aeroacoustic measurements performed by flush-mounted microphone arrays on the walls of closed-section wind tunnels are contaminated by the hydrodynamic pressure fluctuations of the wall's boundary layer. This study evaluates three different microphone cavity geometries for mitigating this issue. Their improvement to the signal-to-noise ratio ...

Experimental study of realistic low–noise technologies applied to a full–scale nose landing gear

The landing gear system is the dominant airframe noise source for most modern commercial aircraft during approach. This manuscript reports the results from the ALLEGRA (Advanced Low Noise Landing (Main and Nose) Gear for Regional Aircraft) project. This project assessed the performance of several highly realistic low–noise technologies (LNTs)...

Assessment of the accuracy of microphone array methods for aeroacoustic measurements

In this paper, the performance of four acoustic imaging methods: conventional frequency domain beamforming (CFDBF), functional beamforming (FUNBF), enhanced high resolution CLEAN–SC (EHR–CLEAN–SC) and generalized inverse beamforming (GIBF), is investigated in terms of accuracy and variability. Three experimental test cases are considered: 1)...

Microphone arrays for imaging of aerospace noise sources

With the continuous growth in demand for air traffic and wind turbines, the noise emissions they generate are becoming an increasingly important issue. To reduce their noise levels, it is essential to obtain accurate information about all the sound sources present. Phased microphone arrays and acoustic imaging methods allow for the estimation of...

Effect of trailing edge serration-flow misalignment on airfoil noise emissions

The broadband noise generated by the scattering of turbulent flow at the trailing edge of a NACA 0018 airfoil with trailing edge serrations is investigated, varying both the airfoil angle of attack and serration flap angle. Acoustic emissions from the trailing edge are measured using a microphone array. The noise level is observed to be...

Acoustic Emissions of Semi-Permeable Trailing Edge Serrations

The trailing edge of a NACA 0018 airfoil is modified through the attachment of serrations with different degrees of permeability. Acoustic beamforming is used to inspect the turbulent boundary layer-trailing edge noise emissions from the unmodified and serrated trailing edges. Different freestream velocities and angles of attack are investigated...