Searched for: subject%3A%22carbon%255C%2Bfibre%255C%2Breinforced%255C%2Bplastic%22
(1 - 11 of 11)
document
Huijer, A.J. (author), Kassapoglou, C. (author), Pahlavan, Lotfollah (author)
Piezoelectric sensors can be embedded in carbon fibre-reinforced plastics (CFRP) for continuous measurement of acoustic emissions (AE) without the sensor being exposed or disrupting hydro- or aerodynamics. Insights into the sensitivity of the embedded sensor are essential for accurate identification of AE sources. Embedded sensors are considered...
journal article 2021
document
Mirtsopoulos, I. (author)
Ever since the idea of truss structures was conceived and later were expanded into three dimensional structures forming space frames, jointing has been a challenge. The evolution of jointing systems includes three main methods: connection with a node, connection with a prefabricated unit and connection without a node (e.g. welding). Delving more...
master thesis 2015
document
Schellekens, J.C.J. (author), De Borst, R. (author)
journal article 1994
document
van der Hoeven, W. (author)
The effect of cooling rate on some mechanical properties of APC-2/AS4 composite was investigated over the range between 1 and 70° C/min. Preconsolidated unidirectional laminates were reprocessed in a hot platen press at controlled cooling rates. Double Cantilever Beam specimens and End Notch Flexure specimens were used to determine the mode I...
report 1993
document
Schellekens, J.C.J. (author), De Borst, R. (author)
journal article 1993
document
't Hart, W.G.J. (author)
The susceptibility of currently used CFRP to impact damage has stimulated the development of improved composites. This new generation of composites usually shows increased toughness and damage tolerance as well as improved tensile performance. This is generally not matched, however, by a similar improvement in compressive properties which then...
report 1991
document
Komorowski, J.P. (author)
This report is the first in a series of literature reviews in which hygrothermal effects on aerospace composite materials (CM) are examined. This first report (Part I) deals primarily with fundamental aspects of the diffusion of moisture into, and from, composite materials. The effects of temperature under both steady state and transient...
report 1983
document
Wanhill, R.J.H. (author)
Flight simulation fatigue crack propagation tests with gust spectrum loading were carried out on laminates of (i) aluminium alloy 2024-T3/carbon-epoxy, (ii) aluminium alloy 7475-T761/carbon-epoxy and (iii) titanium alloy Ti-6Al-4V/carbon-epoxy with nominal weight savings of 30% and 40% as compared to equivalent 2024-T3 Alclad and 7475-T761...
report 1982
document
de Graaf, E.A.B. (author), Rienks, K.J. (author), van Dreumel, W.H.M. (author)
The present report describes the X-ray radiography and subsequent destructive investigation according to metallographic techniques of specimens that were taken from experimental mixed—laminate test panels. Clues for the interpretation of radiopraphs of carbon fibre reinforced composites are given.
report 1980
document
van den Assem, D. (author), Daniels, D.H.W. (author)
report 1978
document
van der Assem, D. (author), Daniels, D.H.W. (author)
report 1977
Searched for: subject%3A%22carbon%255C%2Bfibre%255C%2Breinforced%255C%2Bplastic%22
(1 - 11 of 11)