Report of RILEM TC 267-TRM phase 2: Optimization and testing of the robustness of the R3 reactivity tests for supplementary cementitious materials

The results of phase 1 of an interlaboratory test, coordinated by the RILEM TC 267-TRM “Tests for Reactivity of Supplementary Cementitious Materials” showed that the R³ (rapid, relevant, reliable) test method, by measurement of heat release or bound water, provided the most reliable and relevant determination of the chemical...

Report of RILEM TC 267-TRM phase 3: validation of the R³ reactivity test across a wide range of materials

RILEM TC 267 TRM– “Tests for Reactivity of Supplementary Cementitious Materials” recommends the Rapid Reliable Relevant (R3) test as a method for determining the chemical reactivity of supplementary cementitious materials (SCMs) in Portland cement blends. In this paper, the R3 test was applied to 52 materials from a wide range of conventional...

Influence of the Ms-modulus on the early-age volume change and heat release of slag and fly ash pastes activated by sodium hydroxide and sodium silicate

Blended pastes composed of slag and fly ash (ratio 50:50) are used with sodium hydroxide and sodium silicate as precursors. Each composition has the same solution to binder ratio (S/B) and the Ms-modulus varies between 1.04 and 1.58. All the experiments were conducted at a constant temperature of 20°C. The physical mechanisms related to the...

Experimental Study and Numerical Simulation of the Reaction Process and Microstructure Formation of Alkali-Activated Materials

Alkali-activated materials (AAMs) show promising potentials for use as building materials. Before the utilization, AAMs must satisfy the properties required from the construction sector, such as good durability and long-term service life. These properties mainly depend on the chemical and physical properties of the microstructure of AAMs. In the...

Supercritical water oxidation of quinoline with moderate preheat temperature and initial concentration

This work reports an experimental study on supercritical water oxidation of quinoline. Moderate preheat temperature (420 °C–510 °C) and initial concentration (1 wt%–10 wt%) are selected to address the possibility of utilizing the heat released during the reaction, in order to realize high conversion rate at relatively low preheat temperature....

Characterising Combustion in Diesel Engines: Using parameterised finite stage cylinder process models

Characterising combustion of diesel engines is not only necessary when researching the instantaneous combustion phenomena but also when investigating the change of the combustion process under variable engine operating conditions. An effective way to achieve this goal is to parameterize the combustion process using a finite combustion stage...