Searched for: subject%3A%22monitoring%22
(1 - 20 of 602)

Pages

document
Bellezza, Cinzia (author), Barison, Erika (author), Farina, Biancamaria (author), Poletto, Flavio (author), Meneghini, Fabio (author), Böhm, Gualtiero (author), Draganov, D.S. (author), Janssen, M.T.G. (author), van Otten, Gijs (author)
Geothermal power production may result in significant CO2 emissions as part of the produced steam. CO2 capture, utilisation, subsurface storage (CCUS) and developments to exploit geothermal resources are focal points for future clean and renewable energy strategies. The Synergetic Utilisation of CO2 Storage Coupled with Geothermal Energy...
journal article 2024
document
Daoutidis, Prodromos (author), Lee, Jay H. (author), Rangarajan, Srinivas (author), Chiang, Leo (author), Gopaluni, Bhushan (author), Schweidtmann, A.M. (author), Harjunkoski, Iiro (author), Mercangöz, Mehmet (author), Mesbah, Ali (author)
This “white paper” is a concise perspective of the potential of machine learning in the process systems engineering (PSE) domain, based on a session during FIPSE 5, held in Crete, Greece, June 27–29, 2022. The session included two invited talks and three short contributed presentations followed by extensive discussions. This paper does not...
journal article 2024
document
Veltmeijer, A.V. (author), Naderloo, M. (author), Pluymakers, Anne (author), Barnhoorn, A. (author)
Induced earthquakes are still highly unpredictable, and often caused by variations in pore fluid pressure. Monitoring and understanding the mechanisms of fluid-induced fault slip is essential for seismic risk mitigation and seismicity forecasting. Fluid-induced slip experiments were performed on critically stressed faulted sandstone samples,...
journal article 2024
document
Duives, D.C. (author), Ton, Danique (author)
Crowding is often analyzed using crowd dynamics variables. Yet, it is questionable whether quantitative variables fully describe the perception of crowdedness. This paper presents four case studies into the Pedestrian Level-of-Service (PLoS), featuring a 1) mass event, 2) shopping environment, 3) festival, and 4) touristic hotspot. The...
journal article 2024
document
Kortenbout, A.J. (author), Costerus, Sophie (author), Dudink, Jeroen (author), de Jong, N. (author), de Graaff, Jurgen C. (author), Vos, H.J. (author), Bosch, Johan G. (author)
Objective: Post-operative brain injury in neonates may result from disturbed cerebral perfusion, but accurate peri-operative monitoring is lacking. High-frame-rate (HFR) cerebral ultrasound could visualize and quantify flow in all detectable vessels using spectral Doppler; however, automated quantification in small vessels is challenging...
journal article 2024
document
Grosfeld, J. J. (author), Schoor, M. M. (author), Taormina, R. (author), Luxemburg, W.M.J. (author), Collas, F. P.L. (author)
Current research on riverine macrolitter does not yet provide a theoretic framework on the dynamics behind its accumulation and distribution along riverbanks. In an attempt to better understand these dynamics a detailed field survey of three months was conducted in which location of macrolitter items within a single groyne field along the...
journal article 2024
document
Li, Tianzhi (author), Chen, Jian (author), Yuan, Shenfang (author), Zarouchas, D. (author), Sbarufatti, Claudio (author), Cadini, Francesco (author)
Fatigue damage prognosis always requires a degradation model describing the damage evolution with time; thus, the prognostic performance highly depends on the selection of such a model. The best model should probably be case specific, calling for the fusion of multiple degradation models for a robust prognosis. In this context, this paper...
journal article 2024
document
Muxica, Diego (author), Rivera, Sebastian (author), Orchard, Marcos E. (author), Ahumada, Constanza (author), Jaramillo, Francisco (author), Bravo, Felipe (author), Gutiérrez, José M. (author), Astroza, Rodrigo (author)
This paper presents the design, implementation, and validation of an on-blade sensor system for remote vibration measurement for low-capacity wind turbines. The autonomous sensor system was deployed on three wind turbines, with one of them operating in harsh weather conditions in the far south of Chile. The system recorded the acceleration...
journal article 2024
document
Zheng, L. (author), Hamaza, S. (author)
Drones have been increasingly used in various domains, including ecological monitoring in forests. However, the endurance and noise of drones have limited their deployment to short flight missions above canopies. To address these limitations, we introduce ALBERO: a framework comprising a mechanical solution and an optimal planner to realise...
journal article 2024
document
Ghaderiaram, A. (author), Mohammadi, R. (author), Schlangen, E. (author), Fotouhi, M. (author)
Engineering structures, such as bridges, wind turbines, airplanes, ships, buildings, and offshore platforms, often experience uncertain dynamic loadings due to environmental factors and operational conditions. The lack of knowledge about the load spectrum for these structures poses challenges in terms of design and can lead to either over...
journal article 2024
document
Hu, M. (author), Yue, N. (author), Groves, R.M. (author)
With the improvements in computational power and advances in chip and sensor technology, the applications of machine learning (ML) technologies in structural health monitoring (SHM) are increasing rapidly. Compared with traditional methods, deep learning based SHM (Deep SHM) methods are more efficient and have a higher accuracy. However, due...
journal article 2024
document
Felicita, M.P. (author), Pagella, G. (author), Ravenshorst, G.J.P. (author), Mirra, M. (author), van de Kuilen, J.W.G. (author)
This case study explores the utilization of distributed fiber optic sensors (DFOS) in wooden foundation piles, for assessing and monitoring the stress distribution along their length. Three spruce and three pine foundation piles instrumented with DFOS were driven into the soil in a testing field in Amsterdam and axially loaded in compression....
journal article 2024
document
Eenkhoorn, C. (author), Goos, T.G. (author), Dankelman, J. (author), Franx, Arie (author), Eggink, Alex J. (author)
Introduction: In clinical practice, fetal heart rate monitoring is performed intermittently using Doppler ultrasound, typically for 30 minutes. In case of a non-reassuring heart rate pattern, monitoring is usually prolonged. Noninvasive fetal electrocardiography may be more suitable for prolonged monitoring due to improved patient comfort and...
journal article 2024
document
Hofman, Wout (author), Rukanova, B.D. (author), Tan, Y. (author), Bharosa, Nitesh (author), Ubacht, J. (author), Rietveld, Elmer (author)
The transition towards a circular economy (CE) will require data sharing across different platforms and data spaces of parties operating in a variety of supply chains. From a circular economy compliance monitoring perspective, beyond the access to mandatory data that governments will receive, authorities may benefit from accessing additional...
conference paper 2024
document
Kuai, H. (author), Civera, M. (author), Coletta, G. (author), Chiaia, B. (author), Surace, C. (author)
In structural engineering, offshore structures are undoubtedly among the most exposed to the effects of harsh environmental conditions. The external conditions of these semi-immersed systems involve complex combinations of wave and wind loads. The operating conditions are also unique because oil production platforms are subjected to repeated...
journal article 2024
document
Xiao, Y. (author)
Additively manufacturing can bring opportunities and risk factors to the aerospace industry. On one hand, additive manufacturing allows the manufacturing of structures with geometries that are difficult or impossible to fabricatewith conventional machining procedures. This geometry flexibility may lead to components with a greater strength-to...
doctoral thesis 2023
document
Zeng, Y. (author)
doctoral thesis 2023
document
Ewald, Vincentius (author)
One of the classical solutions to maintain the aircraft structural integrity is to rely on the analysis of non-destructive testing (NDT) inspector with various inspection methods. However, it is relatively expensive in matter of time and costs to train human resources until the certification is reached. Further, in majority of the cases of...
doctoral thesis 2023
document
Scheeren, B. (author)
Highly-loaded low-speed roller bearings form crucial connections in offshore structures, such as heavy-lifting vessels, single-point mooring systems, and wind turbines. In order to safeguard the integrity and reliability of these assets and their operations, a quantitative methodology for condition monitoring of the bearings can be of...
doctoral thesis 2023
document
den Besten, N.I. (author)
Waterlogging is the accumulation of excess water in the rootzone. When soils are waterlogged the rootzone is either saturated or submerged with water. As a result, waterlogging prevents aeration of the rootzone which has adverse effects on crop growth. Waterlogging is an issue in both irrigated and rain-fed agriculture and crop productivity...
doctoral thesis 2023
Searched for: subject%3A%22monitoring%22
(1 - 20 of 602)

Pages