Collection: education
(1 - 20 of 108)

Pages

document
Kortleven, M. (author)
In this research computational fluid dynamics (CFD) is used to model a vertical axis wind turbine. Well known turbulence models | i.e. the k-epsilon and k-omega SST model | are used and compared in their performance against each other and a set of experimental data. The formal research question is "What models are available for the simulation of...
bachelor thesis 2016
document
Tsavlidis, Ioannis (author)
The graduation project was conducted at the upper stage liquid propulsion department of ArianeGroup at the facilities of Airbus DS, Bremen. Based on a series of past flights of Ariane 5 launcher, the aim is to analyze the fluid motion and the pressure fluctuations in the cryogenic propulsion upper stage Liquid Hydrogen (LH...
master thesis 2018
document
Peeters, P.T. (author)
Pipelines with multiphase flow of gas, oil, and water are commonly used in the oil and gas industry. In the presence of offshore platforms or vessels, the pipeline ends with a vertical riser. A possible new concept is to use a single large diameter pipeline along the sea floor that ends into multiple smaller diameter risers. This concept might...
master thesis 2016
document
Jousma, Werner (author)
Cavity buffeting noise is the main contributor to discomfort in sky-dive tunnels. Low frequency noise, generated by self-sustained cavity shear-layer oscillations, similar to automotive sunroof-buffeting noise and side-window buffeting noise, is observed in sky-dive tunnels. Typical low frequencies are not conventionally audible to the human ear...
master thesis 2018
document
Akkermans, Christ (author)
The influence of using different chemistry model and different chemical kinetics schemes on modeling combustion inside a rocket engine igniter are investigated. An igniter for a LOX/CH4 rocket engine is designed and a CFD model is developed which is used to model the designed igniter. Verification and validation methods are discussed.

...
master thesis 2017
document
Koning, W.J.F. (author)
Experimental techniques to measure rotorcraft aerodynamic performance are widely used. However, most of them are either unable to capture interference effects from bodies, or require an extremely large computational budget. The objective of the present research is to develop an XV-15 Tilt Rotor Research Aircraft rotor model for investigation of...
master thesis 2015
document
Desai, Sanjeet (author)
Feadship yachts are designed for the leisure and cruising across the oceans. These luxury yachts are mostly powered by diesel engines or in some cases, a diesel-hybrid system. To prevent the inconvenience and the discomfort arising from the diesel exhaust gases for passengers, Feadship yachts are equipped with an underwater exhaust outlet. These...
master thesis 2018
document
De Baar, J.H.S. (author)
The keel of a sailing yacht has been shown to constitute a significant part of the overall resistance. Where the details of this effect are not yet fully understood, Computational Fluid Dynamics (CFD) analysis might reveal mechanisms unseen to the experimental eye. An important step in CFD application is the simulation of a number of validation...
master thesis 2010
document
Hendriksen, Eduard (author)
A project is under way to replace the ferry crossings in Norway's highway E39 with fixed links, such as highway bridges or tunnels. This thesis research is on the crossing located at the Sognefjord, the widest and deepest of the straight crossings in the E39 highway. Previous thesis projects at IV-Consult have yielded a design for a floating...
master thesis 2018
document
Fatou Gomez, Javier (author)
The computation of complex turbulent flows design optimization processes is currently limited by the lack of accuracy of Reynolds-Averaged Navier-Stokes (RANS) in massively separated flows and the infeasible cost of multiple Large-Eddy Simulation (LES) evaluations. A novel method is presented, injecting data from LES or other high-fidelity...
master thesis 2018
document
Saleh, K. (author)
One of the major problems associated with oil and gas production is the large volume of produced water. Operators around the world are facing significant costs with the treatment and disposal of produced water. Downhole separation, a relatively new technique, has been developed to reduce the costs of produced water and increase oil production....
master thesis 2015
document
Van Oostrom, J. (author)
In a previous study, the optimal re-entry trajectory of Hyperion-2 has been derived. The mission of the vehicle is to measure hypersonic boundary-layer transition, a phenomena in which the laminar boundary layer turns into a turbulent boundary layer. This is an important feature in hypersonic flow to investigate, as it introduces peak heating...
master thesis 2015
document
D' Onofrio, Federica (author)
RANS equations are nowadays widely used in industry because of their affordability in terms of computational costs. They reached a high level of complexity, as they involve systems of non-linear partial differential equations. However they still lack of generality as they are based on closure coefficients determined from fundamental real flow...
master thesis 2017
document
Rawat, Digvijay (author)
An aneurysm refers to the local dilation or ballooning of a blood vessel and if left unchecked, almost every aneurysm continues to grow in size until it eventually ruptures. The abdominal aorta is the most common location for an aneurysm to form and an abdominal aortic aneurysm (AAA) can turn lethal in the event of rupture. Since the current...
master thesis 2017
document
Wieleman, Vera (author)
An accurate prediction of propeller hull interaction is an important step in the design of a new vessel. The prediction of full-scale flow phenomena, which eliminates scale effects, is becoming available due to increasing computational power. However, the complexity of full-scale CFD calculations combined
with a lack of validation data...
master thesis 2018
document
Kagkaras, A. (author)
In Aerospace Engineering the field of Computational Flow Dynamics (CFD) studies the aerodynamic behaviour of aircrafts. What is currently being used to perform CFD simulations are Computer Aided Design (CAD) models of the airplanes, which are usually low-detail industrial design models. Research of new methods for improving the results of the...
master thesis 2006
document
Huijzer, Leonard (author)
The Wanda software package developed by Deltares can used for simulating both steady state and transient fluid flow in pipeline systems. Steady state simulations are used for initial system design and transient flow simulations are used for doing water hammer analysis in pipeline systems. For both types of simulations a system consisting of both...
master thesis 2018
document
Papp, David (author)
New generation combat aircraft are expected to operate over extended flight envelopes, including flight at high flow angles and rapid maneuvers. Conditions beyond traditional limits are giving rise to nonlinear phenomena, such as flow separation, large scale energetic vortices, fluctuations etc. These phenomena have significant impact on...
master thesis 2018
document
De Poli, Matteo (author)
Underground infrastructures and the importance of the people’s safety and structures robustness are relevant and contemporary issues in the civil engineering industry. The demand for this infrastructural typology has developed to such an extent that the need for a better and cost-beneficial knowledge of the risks is necessary.
This thesis...
master thesis 2018
document
Steijger, Miranti (author)
master thesis 2017
Collection: education
(1 - 20 of 108)

Pages