We present the world's first backside-illuminated (BSI) single-photon avalanche diode (SPAD) based on standard silicon-on-insulator (SOI) complementary metal-oxide-semiconductor (CMOS) technology. This SPAD achieves a good dark count rate (DCR) after backside etching, comparable to DCRs of BSI SPADs fabricated on bulk wafers. Unlike bulk-wafer-based BSI SPADs, which typically suffer from poor violet and blue sensitivity, the proposed BSI SPAD features increased near-ultraviolet sensitivity as well as significant sensitivity in the violet and blue spectral ranges, thanks to the ultrathin-body SOI. To the best of our knowledge, this is the best result ever reported for any BSI SPAD in the standard CMOS technology. In addition, it also shows high sensitivity at long wavelengths thanks to the interface between silicon and silicon-dioxide layers. Therefore, it achieves a photon detection probability over 26% at 500 nm and 10% in the 400-875 nm wavelength range at 3 V excess bias voltage. The timing jitter is 119 ps full width at half maximum at the same operation condition at 637 nm wavelength. For the proposed BSI SPAD, the buried oxide layer in SOI wafers is used as an etching stop during the wafer backside-etching process, and therefore it ensures the excellent performance uniformity in large arrays.

@en

Photon-counting imaging technology has applications in many fields such as fluorescence lifetime imaging microscopy (FLIM), time-resolved Raman spectroscopy, 3D imaging, and even space communications. The requirement to detect single photons with picosecond temporal resolution makes single-photon avalanche photodiode (SPAD) a popular choice. Advanced biomedical imaging applications such as pill cameras, retinal prosthesis, and implantable biocompatible monitoring sensors require a compact image system, which can be implanted into a living body. To meet these requirements, novel single-photon image sensor solution needs to be developed, in which new substrate post-processing and backside illumination or even dual-side illumination are core technologies, with inherent CMOS compatibility as a prerequisite. This chapter proposed and demonstrated the world’s first flexible CMOS single-photon avalanche diode image sensor, providing a suitable solution for implantable biomedical imaging or monitoring applications, and wherever a curved imaging plane is essential.@en

We proposed the world’s first flexible ultrathin-body single-photon avalanche diode (SPAD) as photon counting device providing a suitable solution to advanced implantable bio-compatible chronic medical monitoring, diagnostics and other applications. In this paper, we investigate the Geiger-mode performance of this flexible ultrathin-body SPAD comprehensively and we extend this work to the first flexible SPAD image sensor with in-pixel and off-pixel electronics integrated in CMOS. Experimental results show that dark count rate (DCR) by band-to-band tunneling can be reduced by optimizing multiplication doping. DCR by trap-assisted avalanche, which is believed to be originated from the trench etching process, could be further reduced, resulting in a DCR density of tens to hundreds of Hertz per micrometer square at cryogenic temperature. The influence of the trench etching process onto DCR is also proved by comparison with planar ultrathin-body SPAD structures without trench. Photon detection probability (PDP) can be achieved by wider depletion and drift regions and by carefully optimizing body thickness. PDP in frontside- (FSI) and backside-illumination (BSI) are comparable, thus making this technology suitable for both modes of illumination. Afterpulsing and crosstalk are negligible at 2µs dead time, while it has been proved, for the first time, that a CMOS SPAD pixel of this kind could work in a cryogenic environment. By appropriate choice of substrate, this technology is amenable to implantation for biocompatible photon-counting applications and wherever bended imaging sensors are essential.@en