Detection of hazardous toxic gases for air pollution monitoring and medical diagnosis has attracted the attention of researchers in order to realize sufficiently sensitive gas sensors. In this paper, we fabricated and characterized a Titanium dioxide (TiO2)-based gas sensor enhanced using the gold nanoparticles. Thermal oxidation and sputter deposition methods were used to synthesize fabricated gas sensor. X-ray diffraction analysis was used to determine the anatase structure of TiO2samples. It was found that the presence of gold nanoparticles on the surface of TiO2enhances the sensitivity response of gas sensors by up to about 40%. The fabricated gas sensor showed a sensitivity of 1.1, 1.07 and 1.03 to 50 ppm of acetone, methanol and ethanol vapors at room temperature, respectively. Additionally, the gold nanoparticles reduce 50 s of response time (about 50% reduction) in the presence of 50 ppm ethanol vapor; and we demonstrated that the recovery time of the gold decorated TiO2sensor is less than 40 s. Moreover, we explain that the improved performance depends on the adsorption-desorption mechanism, and the chemical sensitization and electronic sensitization of gold nanoparticles.

@en

We propose an induction link based on overlapping arrays to eliminate blank spots on the electromagnetic field for moving object applications. We use two arrays of four aligned coils that have a 50% overlap between the two plates. This mechanism compensates for the internal coil power drop at positions in the boundaries between two adjacent external coils. We showed that if these plates are excited, a uniform electromagnetic field is created in the movement direction of the moving object. This uniform electromagnetic field distribution will result in a constant receiving power at all points in the path of the moving internal coil with the same power consumption of one coil excitation. Power delivery to the moving object tolerance reaches 10% at most, while, in non-overlapped scenarios, it is approximately 50%. In addition, according to the theoretical calculations, printed circuit coils (PCB) for the array are designed for maximum efficiency. We found that the change in distance and dimensions of the receiver coil has a linear effect on power and efficiency. Moreover, a Specific Absorption Rate (SAR) simulation was performed for biocompatibility. In this paper, we investigate and record a 68% electrical power efficiency for the fabricated system. The array consists of eight transmitters coils of the same size and shape and a receiver coil at a distance of 4 cm. Furthermore, the fabricated coil has shown improved efficiency compared to similar studies in the literature and introduces a promising structure for bio-test applications.@en

Wireless power is one of the new promising technologies for IoT applications. The use of arrays for power transfer to free-moving objects has revolutionized wireless power transmission (WPT) applications. Herein, we present an extendable platform for transmitting power to a moving object receiving power from an array. The transmitter (TX) consists of two overlapping layers of square planar coils rotated 45 degrees to each other to provide the best electromagnetic flux coverage. Each layer consists of four coils to further control the power supply to the small receiver (RX) coil. This overlapping star-shaped array is stimulated automatically by a power amplifier. This smart stimulation can deliver uniform power to the receiver regardless of rotation and misalignment inconsistencies by using the geometry of the transmitter array. Moreover, by changing the direction of the current of each small square component in each array using the flower-shaped current, a receiver coil perpendicular to the transmitter’s plate can obtain power comparable with conventional structures. We use ADS-HFSS simulation to verify the fabrication and measurement results. The proposed transmitter achieves an average of 18.2% power transfer efficiency (PTE) to RX and at 90° angular misalignment, 11.5% PTE, while the conventional structure transfers no power to the perpendicular RX coil. A future application of the transmitter can be the investigation of the neurobehavioral of free-moving animals and brain–machine interface studies in medicine. @en