In spite of the increasing diffusion of tunnel boring machines, conventional tunnelling is still preferred for economic reasons in case of short tunnels, unconventional cross sections or irregular tunnel trajectories. In conventional tunnelling, the mechanical response of the tunnel front is a main concern and, when tunnels are excavated in cohesive soils, this is dominated by the time factor, related to geometry, to the mean excavation rate and to the hydro-mechanical properties of the materials involved. This is particularly evident during excavation standstill: front displacements progressively increase with time and, in many cases, the system response under long-term conditions becomes unstable. In conventional tunnelling, a common technique employed to improve the system response (under both short- and long-term conditions) is the installation of fibreglass tubes within the advance core. In this paper, the mechanical response of both unreinforced and reinforced deep tunnel fronts in cohesive soils is experimentally analysed. In particular, the results of a series of 1 g small-scale tests, taking into account both the influence of the excavation rate (the unloading time) on the system response and the evolution with time of the tunnel face displacements, induced by a rapid reduction in the horizontal stress applied on the tunnel face, are reported.

In spite of the increasing diffusion of tunnel boring machines, conventional tunnelling is still largely employed in the excavation of both deep and shallow tunnels characterized by a particularly irregular tracing. Under difficult ground conditions, in conventional tunnelling, the front is frequently reinforced by using fibreglass tubes partially removed during the excavation. This technique is expensive, time-consuming and its design is based on either empirical or very simplified theoretical formulas. Thus, the ultimate objective of the research developed by the authors is to introduce a more sophisticated design approach for this front reinforcement technique. A first step in this direction is this numerical study, in which the mechanical response of deep tunnel faces under undrained conditions is analysed by employing the front characteristic curve: a useful tool largely employed in the literature in analogy with what done for the cavity. The main result of this paper is the “Front Mother Characteristic” curve, obtained by introducing appropriate non-dimensional variables, allowing the designer, once both the system geometry and the soil mechanical properties are assigned, to assess the displacements of tunnel fronts without performing any numerical analysis.