The occurrence and removal of microplastics (MPs) in drinking water treatment plants (DWTPs) have been evaluated based on particle number, while the mass concentration and removal characteristics based on the mass of MPs, and especially nanoplastics (NPs), remain unknown. This study employed pyrolysis gas chromatography-mass spectrometry (Py-GC/MS) to determine the mass concentration of MPs and NPs with different size ranges (0.01-1, 1-50, and 50-1000 μm) across the entire treatment process in a DWTP. The total polymers were measured at 9.63 ± 1.52 μg/L in raw water and 0.77 ± 0.05 μg/L in treated water, with the dominant polymers being polypropylene and polyethylene terephthalate. NPs (0.01-1 μm) accounted for only 3.2-5.3% of the total polymers, with an average concentration of 0.38 μg/L in raw water and 0.04 μg/L in treated water. Notably, NPs and sub-MPs (1-50 μm) demonstrated relatively low efficiency in the DWTP at 88.9 ± 3.2 and 88.0 ± 2.5%, respectively, compared with that of the large MPs (50-1000 μm) at 92.9 ± 0.3%. Overall, this study examined the occurrence of MPs and NPs, in a DWTP, emphasizing the significance of considering the mass concentration of MPs and NPs when assessing their pollution levels and removal characteristics.

Premise plumbing plays an essential role in determining the final quality of drinking water consumed by customers. However, little is known about the influences of plumbing configuration on water quality changes. This study selected parallel premise plumbing in the same building with different configurations, i.e., laboratory and toilet plumbing. Water quality deteriorations induced by premise plumbing under regular and interrupted water supply were investigated. The results showed that most of the water quality parameters did not vary under regular supply, except Zn, which was significantly increased by laboratory plumbing (78.2 to 260.7 µg/l). For the bacterial community, the Chao1 index was significantly increased by both plumbing types to a similar level (52 to 104). Laboratory plumbing significantly changed the bacterial community, but toilet plumbing did not. Remarkably, water supply interruption/restoration led to serious water quality deterioration in both plumbing types but resulted in different changes. Physiochemically, discoloration was observed only in laboratory plumbing, along with sharp increases in Mn and Zn. Microbiologically, the increase in ATP was sharper in toilet plumbing than in laboratory plumbing. Some opportunistic pathogen-containing genera, e.g., Legionella spp. and Pseudomonas spp., were present in both plumbing types but only in disturbed samples. This study highlighted the esthetic, chemical, and microbiological risks associated with premise plumbing, for which system configuration plays an important role. Attention should be given to optimizing premise plumbing design for managing building water quality.