In this article, the wrong figure appeared as Figures 1 and 2; the figure should have appeared as shown below Figure 1 (right side of the figure only): (Figure presented.) Figure 2: (Figure presented.)

In this article, the wrong figure appeared as Figures 1 and 2; the figure should have appeared as shown below Figure 1 (right side of the figure only): (Figure presented.) Figure 2: (Figure presented.)

In this article, the wrong figure appeared as Figures 1 and 2; the figure should have appeared as shown below Figure 1 (right side of the figure only): (Figure presented.) Figure 2: (Figure presented.)

We present a feasibility study for the high-redshift galaxy part of the Science Verification Campaign with the 220–440 GHz deshima 2.0 integrated superconducting spectrometer on the ASTE telescope. The first version of the deshima 2.0 chip has been recently manufactured and tested in the lab. Based on these realistic performance measurements, we evaluate potential target samples and prospects for detecting the [CII] and CO emission lines. The planned observations comprise two distinct, but complementary objectives: (1) acquiring spectroscopic redshifts for dusty galaxies selected in far-infrared/mm-wave surveys; (2) multi-line observations to infer physical conditions in dusty galaxies.

Integrated superconducting spectrometer (ISS) technology will enable ultra-wideband, integral-field spectroscopy for (sub)millimeter-wave astronomy, in particular, for uncovering the dust-obscured cosmic star formation and galaxy evolution over cosmic time. Here, we present the development of DESHIMA 2.0, an ISS for ultra-wideband spectroscopy toward high-redshift galaxies. DESHIMA 2.0 is designed to observe the 220–440 GHz band in a single shot, corresponding to a redshift range of z = 3.3–7.6 for the ionized carbon emission ([C II] 158 μ m). The first-light experiment of DESHIMA 1.0, using the 332–377 GHz band, has shown an excellent agreement among the on-sky measurements, the laboratory measurements, and the design. As a successor to DESHIMA 1.0, we plan the commissioning and the scientific observation campaign of DESHIMA 2.0 on the ASTE 10-m telescope in 2023. Ongoing upgrades for the full octave-bandwidth system include the wideband 347-channel chip design and the wideband quasi-optical system. For efficient measurements, we also develop the observation strategy using the mechanical fast sky-position chopper and the sky-noise removal technique based on a novel data-scientific approach. In the paper, we show the recent status of the upgrades and the plans for the scientific observation campaign.

The next technological breakthrough in millimeter–submillimeter astronomy is three-dimensional imaging spectrometry with wide instantaneous spectral bandwidths and wide fields of view. The total optimization of the focal-plane instrument, the telescope, the observing strategy, and the signal-processing software must enable efficient removal of foreground emission from the Earth’s atmosphere, which is time-dependent and highly nonlinear in frequency. Here, we present Time-dependent End-to-end Model for Post-process Optimization (TiEMPO) of the DEep Spectroscopic HIgh-redshift MApper (DESHIMA) spectrometer. TiEMPO utilizes a dynamical model of the atmosphere and parameterized models of the astronomical source, the telescope, the instrument, and the detector. The output of TiEMPO is a time stream of sky brightness temperature and detected power, which can be analyzed by standard signal-processing software. We first compare TiEMPO simulations with an on-sky measurement by the wideband DESHIMA spectrometer, and find good agreement in the noise and sensitivity. We then use TiEMPO to simulate the detection of the line emission spectrum of a high-redshift galaxy using the DESHIMA 2.0 spectrometer in development. The TiEMPO model is open source. Its modular and parametrized design enables users to adapt it to optimize the end-to-end performance of spectroscopic and photometric instruments on existing and future telescopes

Low-loss deposited dielectrics will benefit superconducting devices such as integrated superconducting spectrometers, superconducting qubits, and kinetic inductance parametric amplifiers. Compared with planar structures, multilayer structures such as microstrips are more compact and eliminate radiation loss at high frequencies. Multilayer structures are most easily fabricated with deposited dielectrics, which typically exhibit higher dielectric loss than crystalline dielectrics. We measure the subkelvin and low-power microwave and millimeter-submillimeter-wave dielectric loss of hydrogenated amorphous silicon carbide (a-SiC:H), using superconducting chips with Nb-Ti-N/a-SiC:H/Nb-Ti-N microstrip resonators. We deposit the a-SiC:H by plasma-enhanced chemical vapor deposition at a substrate temperature of 400°C. The a-SiC:H has a millimeter-submillimeter loss tangent ranging from 0.9×10-4 at 270 GHz to 1.5×10-4 at 385 GHz. The microwave loss tangent is 3.1×10-5. These are the lowest low-power subkelvin loss tangents that have been reported for microstrip resonators at millimeter-submillimeter and microwave frequencies. The a-SiC:H films are free of blisters and have low stress: -20 MPa compressive at 200-nm thickness to 60 MPa tensile at 1000-nm thickness.

A superconducting microstrip half-wavelength resonator is proposed as a suitable band-pass filter for broadband moderate spectral resolution spectroscopy for terahertz (THz) astronomy. The proposed filter geometry has a free spectral range of an octave of bandwidth without introducing spurious resonances, reaches a high coupling efficiency in the pass-band and shows very high rejection in the stop-band to minimize reflections and cross-talk with other filters. A spectrally sparse prototype filter-bank in the band 300400 GHz has been developed employing these filters as well as an equivalent circuit model to anticipate systematic errors. The fabricated chip has been characterized in terms of frequency response, reporting an average peak coupling efficiency of 27% with an average spectral resolution of 940.

GroundBIRD is a ground-based experiment for a precise observation of the cosmic microwave background (CMB) polarizations. To achieve high sensitivity at large angular scales, we adopt three features in this experiment: fast rotation scanning, microwave kinetic inductance detector (MKID), and cold optics. The rotation scanning strategy has the advantage to suppress 1/f noise. It also provides a large sky coverage of 40%, which corresponds to the large angular scales of l∼ 6. This allows us to constrain the tensor-to-scalar ratio by using low l B-mode spectrum. The focal plane consists of 7 MKID arrays for two target frequencies, 145 GHz and 220 GHz band. There are 161 pixels in total, of which 138 are for 145 GHz and 23 are for 220 GHz. This array is currently under development, and the prototype will soon be evaluated in telescope. The GroundBIRD telescope will observe the CMB at the Teide observatory. The telescope was moved from Japan to Tenerife and is now under test. We present the status and plan of the GroundBIRD experiment.

GroundBIRD is a ground-based experiment for a precise observation of the cosmic microwave background (CMB) polarizations. To achieve high sensitivity at large angular scales, we adopt three features in this experiment: fast rotation scanning, microwave kinetic inductance detector (MKID), and cold optics. The rotation scanning strategy has the advantage to suppress 1/f noise. It also provides a large sky coverage of 40%, which corresponds to the large angular scales of l∼ 6. This allows us to constrain the tensor-to-scalar ratio by using low l B-mode spectrum. The focal plane consists of 7 MKID arrays for two target frequencies, 145 GHz and 220 GHz band. There are 161 pixels in total, of which 138 are for 145 GHz and 23 are for 220 GHz. This array is currently under development, and the prototype will soon be evaluated in telescope. The GroundBIRD telescope will observe the CMB at the Teide observatory. The telescope was moved from Japan to Tenerife and is now under test. We present the status and plan of the GroundBIRD experiment.

DESHIMA 2.0 is a spectrometer for astronomical applications targeting sources at sub-mm wavelengths from 240GHz to 720GHz. The design for its wide band Quasi-Optical system was presented in the previous works. In this work, the experimental validation of the beam pattern of the system at the lower end of its frequency band is presented. The measurement for the complete frequency band of the system is ongoing and will be presented at the conference.

We present the development of a background-limited kilo-pixel imaging array of ultrawide bandwidth kinetic inductance detectors (KIDs) suitable for space-based THz astronomy applications. The array consists of 989 KIDs, in which the radiation is coupled to each KID via a leaky lens antenna, covering the frequency range between 1.4 and 2.8 THz. The single pixel performance is fully characterised using a representative small array in terms of sensitivity, optical efficiency, beam pattern and frequency response, matching very well its expected performance. The kilo-pixel array is characterised electrically, finding a yield larger than 90% and an averaged noise-equivalent power lower than 3 × 10^{- 19} W/Hz^{1 / 2}. The interaction between the kilo-pixel array and cosmic rays is studied, with an expected dead time lower than 0.6% when operated in an L2 or a similar far-Earth orbit.