This research describes how thermal fractures impact the near-wellbore (NWB) region of a depleted gasfield in a carbon sequestration project. As CO2 is usually injected in its supercritical phase, the injection fluid is injected on high pressures and low temperatures. This is in high contrast with the depleted gasfields, which have a low reservoir pressure. The increase in pressure and decrease in temperature causes a thermoporoelastic response, resulting in a reduction of stress inside the reservoir. Once the fracture initiation stress, the so-called fracture stress, is reached, thermal fractures form.

Thermal fractures form only due to extensive cooling of the reservoir. The fractures impact the NWB region; due to opening of fractures there is a drop in pressure in the bottomhole pressure (BHP). This increases the reservoir's injectivity. This research uses CMG GEM to model this. The simulation uses a homogeneous box dual permeability model with the model being initialized as a generalized depleted gas reservoir in the North Sea. To model the fractures, the Barton Bandis model is used. This model changes the permeability in a fracture cell once fracture conditions are met.

From this model, the moment of fracturing (fracture time), the fracture halflength and the injectivity of the reservoir is researched by performing a sensitivity analysis on key parameters. It is found that the thermal fractures propagate conform to the propagation of the coldest part of the thermal front. The thermal front propagates further once the fracture conditions are met sooner due to fluid highways or when the pressure build up in the reservoir is slower.

The sensitivity on the geomechanical parameters showed that only the stress conditions in the reservoir changed, causing the injection constant to change and thus a different fracture time. The way the reservoir reacted to the initiation of fractures was the same; the injectivity was improved similarly for each parameter.

The effective permeability (thickness and permeability) determines, together with the injection rate, the way the pressure builds up in the reservoir changes the increase of injectivity due to fracturing slightly. Increasing the reservoir volume causes a slower pressure build-up inside of the reservoir, allowing the thermal front to propagate further and thus longer fracture lengths.

Lastly, the sensitivity on the thermal effects showed that a higher difference between the reservoir and injection temperature causes the fracture to be less dependent on the increase of pressure to fracture, resulting in earlier fracturing and longer fracture halflength. The pressure build-up is not changed, so the injectivity remains similar to the basecase scenario.

All in all, this thesis gives an insight on how key parameters impact thermal fracture behavior. It also shows what range of parameters can be expected. Combining these two gives an insight on what parameters the focus should be on to better describe the behavior of thermal fractures, to economize the operation by leaving out or including extensive data collection on key parameters. This helps to improve the injection strategy with CO2 injection projects in depleted gasfields.