Tidal flats are typically rich in fine-grained sediments, with tidal currents serving as the dominant hydrodynamic force. Sediment transport, mainly in the form of suspended load, is especially active in the mid- to low-tidal zones, where silt-rich sediments prevail. In these zones, variations in silt content significantly influence sediment suspension dynamics. To investigate the effect of silt content on the suspension behaviours of sand-silt mixtures under unidirectional flow, a series of experiments has been conducted in an annular flume. Sediment samples collected from silt-enriched tidal flats were remixed into seven types of sediment beds with the silt content ranging from 19 % to 79 %. Results indicate that under steady current conditions, the suspended sediment concentration (SSC) in sand-silt mixtures increased toward equilibrium. Sediment beds with 36 %–60 % silt content exhibited two-stage erosion behaviour, each marked by distinct characteristics. At low to moderate shear stress (0.18–0.74 Pa), smoother bed surfaces and hiding-exposure effects led to higher near-bed velocities and lower equilibrium SSCs. At higher shear stress levels (1.00–1.23 Pa), this behaviour shifted, with prolonged suspension development becoming the key feature. Based on the experimental findings, we further re-calibrated the equations predicting equilibrium SSC, which can be well described by a modified excess shear stress to the power of two. Subsequently, we investigated the boundary conditions that govern sediment suspension to model the observed suspension process. Building on the boundary condition prescribing a constant upward sediment flux, an asymptotic upward flux condition, which represents the delayed erosion response due to the resistance of silty bed structure, has been introduced and demonstrated as the most feasible. Furthermore, the development of SSC towards equilibrium was investigated. This process is well characterised by a time scale, which becomes notably larger for sediment beds with 36 %–60 % silt content at high velocity levels, reflecting their delayed response in suspension. These findings elucidate key mechanisms governing silt-dominated sediment erosion, enhancing predictive capabilities in modelling mixed sediment transport.

Wave height attenuation in vegetation canopies is often all attributed to the drag force exerted by vegetation, whereas other potential dissipation process is often neglected. Previous studies without vegetation have found that opposing currents can induce wave breaking and greatly increase dissipation. It is not clear if similar process may also occur in vegetation canopies. We conducted systematic flume experiments to show that wave breaking in opposing currents can occur in vegetated flows, but only in submerged canopies with shear currents above vegetation top. Subsequently, we developed a new analytical model to understand and assess the contribution of both drag-induced dissipation in the lower vegetation layer and current-induced breaking in the upper free layer. A new generic drag coefficient relation was applied in the model to quantify drag-induced dissipation with various current-wave combinations. It shows that breaking induced by opposing currents constitutes an essential part (up to 87%) of the total dissipation, which leads to considerably higher dissipation than the cases with following currents. Breaking can occur with various submergence ratios and with small opposing currents in the submerged vegetation field. It indicates that similar breaking process is likely to occur in real vegetation fields. The present study reveals and quantifies the current-induced wave breaking process that has not been reported before, which can improve our understanding of vegetation wave dissipation capacity in field conditions.