Effect of P₂O₅ incorporated in slag on the hydration characteristics of cement-slag system

This paper presents the influence of P₂O₅ incorporated in slag on the hydration characteristics of cement-slag system. It was found that the gradual addition of phosphorus oxide in slag did not change overall mineralogy of the hydration products. Except hydration retardation in the dormant stage, chemically bound water...

Improving structural build-up of limestone-calcined clay-cement pastes by using inorganic additives

In 3D concrete printing, fast structuration is a prerequisite for ideal buildability. This paper aims to study the impact of inorganic additives, i.e., CaCl₂ and gypsum, on structural build-up and very early-age hydration of limestone-calcined clay-cement (LC3) pastes within the first 70–80 min. Results show that, increasing the...

On the chemo-mechanical evolution process of high-volume slag cement paste

This study investigated the evolution process of high-volume slag cement (HVSC) paste from a chemo-mechanical standpoint. HVSC specimens with a 70 w.t. % slag replacement rate were studied at various ages. Evolution of phase assemblage, microstructure development, and micromechanical properties were analyzed using TGA/XRD/MIP/SEM-EDS and nano...

Can superabsorbent polymers be used as rheology modifiers for cementitious materials in the context of 3D concrete printing?

Autogenous shrinkage may be a critical issue concerning the use of limestone-calcined clay-cement (LC3) in high-performance concrete and 3D printable cementitious materials, which have relatively low water to binder (W/B) ratio. Adding an internal curing agent, i.e., superabsorbent polymer (SAP), could be a viable solution in this context....

Rheology control of limestone calcined clay cement pastes by modifying the content of fine-grained metakaolin

Limestone-calcined clay-cement (LC3), as one of the most promising sustainable cements, has been under development over the past decade. However, many uncertainties remain regarding its rheological behaviors, such as the metakaolin content of calcined clay. This study aims to investigate the effect of increasing the content of fine-grained...

Fresh properties of limestone-calcined clay-slag cement pastes

Formulation of quaternary blended system containing ordinary Portland cement or clinker, slag, limestone and calcined clay (LC2) appeared to be a viable approach to developing low-clinker cements without severely sacrificing mechanical performance at later ages. This paper investigates the effect of two material parameters, i.e., LC2-to-slag...

The effect of slag chemistry on the reactivity of synthetic and commercial slags

In this paper, both synthetic slag and commercial slag covering the common composition range were employed to estimate the correlation between slag chemistry and reactivity through hydraulicity and dissolution tests. It was found that slag reactivity was favorably affected by increasing Al₂O₃ and MgO contents, while the...

3D printing of calcined clay-limestone-based cementitious materials

This paper aims to investigate the influences of high Portland cement substitutions (>60 wt%) by low-grade calcined clay (CC) and limestone (LF) on 3D concrete printability, stiffness evolution and early-age hydration. Results show that, with the same dosage of admixtures (superplasticizer and viscosity modifier), increasing LF and CC...

Toward nonlinear modeling of meander evolution

Nonlinear simulation of meander evolution

Evolution of meanders, a complex morpho-dynamic process, has been the focus of research challenging river engineers for decades. The study replicates the natural evolution of meandering processes by coupling the Bank Erosion and Retreat Model (BERM, by Chen and Duan) with a nonlinear flow model (by Blanckaert and de Vriend). Distinguished from...