Recycling of Aluminosilicate-Based Solid Wastes through Alkali-Activation: Preparation, Characterization, and Challenges

Recycling aluminosilicate-based solid wastes is imperative to realize the sustainable development of constructions. By using alkali activation technology, aluminosilicate-based solid wastes, such as furnace slag, fly ash, red mud, and most of the bio-ashes, can be turned into alternative binder materials to Portland cement to reduce the carbon...

Release of phosphorus through pretreatment of waste activated sludge differs essentially from that of carbon and nitrogen resources: Comparative analysis across four wastewater treatment facilities

The accumulation of phosphorus in activated sludge in wastewater treatment plants (WWTPs) provides potential for phosphorus recovery from sewage. This study delves into the potential for releasing phosphorus from waste activated sludge through two distinct treatment methods—thermal hydrolysis and pH adjustment. The investigation was conducted...

Response of hydrogeological processes in a regional groundwater system to environmental changes: A modeling study of Yinchuan Basin, China

The sustainable development of groundwater resources in arid and semi-arid regions is a challenging task hindered by climate change and human activities. The rational utilization and management of groundwater resources is, therefore, dependent on an understanding of the influences of human and climatic factors on the spatial distribution of...

Supplementary control based on current source coupling for improving dynamic characteristics of active distribution network

Supplementary control (SC) technology is widely leveraged by power supply companies in active distribution networks (ADNs) to improve their stability and dynamic characteristics. Yet, the existed SCs are generally implemented from inside the converter controllers of distributed generators (DGs) or active loads, so there is a need to redesign...

Investigation on the DC CB Performance during a Current Interruption Failure at First Current Zero

The vacuum interrupter is used as the key component of an active DCCB due to its excellent interruption and dielectric recovery characteristics after current zero. The vacuum interrupter can only interrupt the fault currents below the limitation of a critical di/dt and TIV, otherwise it causes a reignition and the interruption failure. In...