Defining “k _f-factors” for threshold reactions

The k₀-method (De Corte in The k₀-standardization method: move to the optimization of neutron activation analysis. Habil. Thesis, Ghent University, Belgium, 1987) was developed solely for the use of (n, γ) nuclear reactions in neutron activation analysis. For this, a definition of only the thermal and epi-thermal flux...

The 2021 IAEA software intercomparison for k₀-INAA

In order to establish the variation between results in mass fractions due to software implementation, as measured by the k₀-method for INAA, the IAEA has organized a software intercomparison. A complete set of test spectra and associated information was assembled. Efficiency curves, neutron spectrum parameters, correction factors...

Ion beam analysis (IBA) and instrumental neutron activation analysis (INAA) for forensic characterisation of authentic Viagra® and of sildenafil-based illegal products

Illegal trafficking of pharmaceutical products by criminal organisations is a global threat for public health. Drugs for erectile dysfunction such as phosphodiesterase type 5 inhibitors are the most commonly counterfeited medicines in Europe. The search of possible toxic chemical substances in seized products is needed to provide early...

Large-sample neutron activation analysis in mass balance and nutritional studies

Low concentrations of elements in food can be measured with various techniques, mostly in small samples (mg). These techniques provide only reliable data when the element is distributed homogeneously in the material to be analysed either naturally or after a homogenisation procedure. When this is not the case or homogenisation fails, a...

Large sample neutron activation analysis avoids representative sub-sampling and sample preparation difficulties: An added value for forensic analysis

A crucial part of any chemical analysis is the degree of representativeness of the measurand(s) in the test portion for the same measurands in the object, originally collected for investigation. Such an object usually may have either to be homogenized and sub-sampled, or digested/dissolved. Any of these steps introduce sampling errors, risk...

Trendwatcher or trendsetter: 50 years of MTAA

The development on neutron activation analysis (NAA) into a technique of practical interest effectively started about 60 years ago, when nuclear reactors became available and widely accessible as intense sources of neutrons. During 50 out these 60 years, the series of Modern Trends in Activation Analysis (MTAA) Conferences acted as a true...

Opportunities for innovation in neutron activation analysis

Neutron activation laboratories worldwide are at a turning point at which new staff has to be found for the retiring pioneers from the 1960s–1970s. A scientific career in a well-understood technique, often characterized as ‘mature’ may only be attractive to young scientists if still challenges for further improvement and inspiring new...

Performance and robustness of a multi-user, multi-spectrometer system for INAA

The laboratory for instrumental neutron activation analysis at the Reactor Institute Delft, Delft University of Technology uses a network of 3 gamma-ray spectrometers with well-type detectors and 2 gamma-ray spectrometers with coaxial detectors, all equipped with modern sample changers, as well as 2 spectrometers with coaxial detectors at the...

Large sample neutron activation analysis of a ceramic vase

Large Sample Neutron Activation Analysis (LSNAA) was applied to perform non-destructive elemental analysis of a ceramic vase. Appropriate neutron self-shielding and gamma ray detection efficiency calibration factors were derived using Monte Carlo code MCNP5. The results of LSNAA were compared against Instrumental Neutron Activation Analysis ...