- document
-
van Dijk, Bob (author)In the Netherlands, numerous bridges face reassessment. During this assessment, it is observed that in some cases, the applied shear reinforcement (stirrups) does not meet the detailing requirement given in the national annex of the NEN-EN 1992-2. This requirement, which states that the stirrups must enclose the longitudinal reinforcement to...master thesis 2024
- document
-
Kisoensingh, Arvind (author)Flexural shear failure is a brittle failure mode that can occur in reinforced concrete (RC) beams without stirrups due to the combination of flexural and shear stresses. The failure mode begins with vertical flexural cracks at the bottom of the RC beam central span area due to flexural tensile stresses, followed by diagonal cracks. During...master thesis 2023
- document
-
de Putter, Arjen (author), Hendriks, M.A.N. (author), Rots, J.G. (author), Yang, Y. (author), Engen, Morten (author), van den Bos, Ab A. (author)Nineteen 2D nonlinear finite element analysis (NLFEA) solution strategies were benchmarked against a wide variety of 101 experiments on reinforced concrete beams failing in bending, flexural shear, or shear compression. The relatively high number of solution strategies was motivated by the conviction that choices for the constitutive models,...journal article 2022
- document
-
Strookman, Mark (author)Non-linear finite element analysis (NLFEA) is a powerful numerical solution method that can enhance accurate determination of the structural resistance for a more efficient design. However, the implementation of NLFEA for the design of reinforced concrete structures is lagging behind as related uncertain- ties have not been quantified adequately...master thesis 2021
- document
-
Mustafa, S. (author), Singh, S. (author), Lukovic, M. (author)Strain Hardening Cementitious Composite (SHCC) is applied on the tension side of a flexural member in order to improve crack-width control of reinforced concrete and its effectiveness is investigated for varying treatment of the interface between SHCC and concrete. A four-point bending test configuration is used and the interface is varied...conference paper 2020
- document
-
Tiwari, Anshuman (author)Shear cracking in slender reinforced concrete beams with thin webs can result in significant shear crack width and deflection which is usually ignored in practice due to lack of availability of the engineering models in design codes. This can lead to unconservative predictions of the crack width and total deflection in the SLS (Serviceability...master thesis 2019
- document
-
Lukovic, M. (author), Hordijk, D.A. (author), Huang, Z. (author), Schlangen, E. (author)Strain Hardening Cementitious Composite (SHCC) is an innovative material which, due to the special material composition and the addition of fibres, exhibits a controlled microcracking behaviour under tensile stresses. As such it might be a promising material for improvement of durability of concrete structures.<br/><br/>An experimental study was...journal article 2019
- document
-
Zarate Garnica, Gabriela (author)Digital Image Correlation analysis is performed to obtain measurements of the crack kinematics of four reinforced concrete beams without shear reinforcement. The results are used to implement the critical shear displacement theory. This new theory proposes that the opening of the critical inclined crack can be considered as a lower bound for the...student report 2018
- document
- Evangeliou, P. (author) master thesis 2016
- document
-
Belletti, B. (author), Damoni, C. (author), Hendriks, M.A.N. (author)Three years ago, the Dutch Ministry of Infrastructure and the Environment initiated a project to re-evaluate the carrying capacity of existing bridges and viaducts (e.g. reinforced and pre-stressed concrete beams and slabs). Due to the increase of traffic and the reallocation of emergency lanes to traffic lanes, the safety verification of some...conference paper 2013
- document
- Sluys, L.J. (author), De Borst, R. (author) journal article 1992