Optical Filter Coated PV Cell for Noise-free Outdoor LiFi

Optical Filter Coated PV Cell for Noise-free Outdoor LiFi

Ibrahim, Aya (TU Delft Electrical Engineering, Mathematics and Computer Science)

Ziar, H. (mentor)
Manganiello, P. (graduation committee)
Muttillo, M. (graduation committee)
Zhou, Y. (graduation committee)

Delft University of Technology

Electrical Engineering | Sustainable Energy Technology

2023-08-28

In today’s society, the need for alternate high-speed data transmission solutions has increased due to the radio frequency (RF) spectrum’s growing congestion. Visible Light Communication (VLC)-based LiFi has emerged as a possible alternative to current wireless technologies like WiFi. The difficulty, though, is that the photodiode performance as a receiver for VLC under outdoor conditions rapidly degrades. To solve this problem, the photodiode receiver was replaced by a PV cell receiver with the primary advantage of being optimized for outdoor conditions.
While earlier research has concentrated on light and modulation optimization to
improve the performance of VLC systems, our research adopts a novel strategy by
analyzing the effect of different light wavelengths on seven different PV cell technologies in hopes to design an optical filter and realize noise-free VLC for PV cells. We specifically are interested in identifying the LED wavelength that has the greatest bandwidth in order to increase the possible data transmission speeds in PV-VLC systems. In order to do this, a thorough characterization of several colored LEDs with different wavelengths was carried out across seven PV technologies, including PERC, AL-BSF (5INCH), AL-BSF (6INCH), SHJ, IBC, Busbar-free Al BSF, and TOPCon. Each LED wavelength was tested under three different intensities of light (100, 300, and 500 W/m2).
In terms of PV technology, TOPCon demonstrated superior performance at low bias voltages, while Busbar-Free Al BSF(EEPV) outperformed the other PV technologies at higher bias voltages, especially at the maximum power point. Furthermore, the analysis of light intensity revealed that the bandwidth does not only depend on capacitance but also on the internal resistance of the PV laminate. For the c-Si solar laminates tested the considerably larger resistance at lower light intensities in the bias voltage interval from 150mV to 450mV resulted in lower bandwidths at lower light intensities. The measurement results under different LED colors, concluded that when operating near maximum power point, the variation in bandwidth between different colored LEDs could significantly affect data rates, particularly when considering the higher SNR results at lower bias voltages that contribute to achieving faster data rates in the PV-VLC system.

LiFi
VLC
PV Receiver
Bandwidth

http://resolver.tudelft.nl/uuid:63d4086e-9f80-4bcd-a659-8f09e4620bd7

2025-08-28

Student theses

master thesis

© 2023 Aya Ibrahim