Searched for: subject:"set%5C-up"
(1 - 12 of 12)
document
Pol, Lucas (author)
The project named production biospheres created a process design aimed on the adaptive reuse of the Plots In The Woods site on the Hembrug terrain near Zaandam. The landscape and urban design for the site is based on methods used by landscape architects and ecologists based on the three terms cultivate, stage and set up, not just creating. The...
master thesis 2020
document
Geel, Patrick (author), Kleijweg, Zep (author)
This project is to design and implement a reconfigurable measurement interface for Internet of Things sensors, for the Microelectronics Department of the Delft University of Technology. This thesis will discuss the functionality and design process taken in designing such a reconfigurable measurement interface, focusing on generating signals and...
bachelor thesis 2019
document
van Dam, Anne (author)
Safe surgical and anesthetic care is not available to 5 billion people worldwide. Many problems that are encountered when providing surgical care are related to surgical equipment. A lot of surgical equipment is designed for the use in High-Income Countries (HICs) and not specifically for Low-and-Middle Income countries (LMICs). One appliance,...
master thesis 2018
document
Stap, Merijn (author)
Bridges are a crucial part of the dense Dutch highway network. Almost 50% of the current bridges are built between 1960 and 1980 for an intended service life of 50 years and thus they might reach the end of their lifetime in the near future. This strongly indicates that a large challenge can be expected regarding infrastructural replacement.<br/...
master thesis 2017
document
Beutick, Erik (author)
A time-dependent capacity increase has often been observed for driven displacement piles in sand. Long-term bearing capacity increase after dissipation of excess pore water pressure is referred to as set-up. Significant increases in axial capacity have been reported where the rate of set-up varied between 15 and 75% per log cycle of time. <br/>...
master thesis 2017
document
Van Rinsum, G.P. (author)
This document includes a survey whether the wind set-up formula is valid and accurate in case of irregularly shaped lakes with a strong varying water depth. The formula is designed for a pure theoretical situation, the question is whether the formula is valid in situations that differ a lot from the theoretical one. The research is carried out...
bachelor thesis 2015
document
Bodde, W.P. (author)
Coral reefs are highly valuable structures in many respects and it is increasingly important to understand hydrodynamics and morphodynamics around reefs to be able to better protect them and their hinterland. Flume experiments were performed on a scaled fringing reef in the laboratory facilities of Deltares in Delft. The objective of this thesis...
master thesis 2013
document
De Lange, D.A. (author)
An increase over time in bearing capacity of displacement piles is often found in the field. This phenomenon is called pile set-up. The increase is predominantly caused by an increase in shaft resistance and is observed even until 1000 days after installation. In the Dutch situation, a proposed tightening of the design standard for pile...
master thesis 2013
document
Zhang, N. (author)
The Wireless Lighting Control System has drawn intensive attention in the recent years due to the potential for huge cost savings as well as increased convenience. Commonly seen Wireless Lighting Control Systems utilize Zigbee, KNX and Z-WAVE; whereas little attention has been given to Wi-Fi because of unsolved limitations. The purpose of this...
master thesis 2012
document
Van der Linde, P. (author)
During the fall of 2003, an extensive measurement campaign called the “Nearshore Canyon Experiment” (NCEX) was set up along the coast of La Jolla, California. The project site covered an area in which two submarine canyons are located, respectively La Jolla and Scripps Submarine Canyon. Over 20 institutions collaborated on recording the...
master thesis 2010
document
Bosman, G. (author), Maaskant, B. (author)
De provincie Friesland wil een meer gestructureerde aanpak voor de bepaling van de hoogtes van boezemkades. Om goed te kunnen dimensioneren is een gedetailleerd model nodig met maatgevende waterstanden. Het huidige model, gemaakt door het Wetterskip Fryslân, is gebaseerd op 37 meetpunten verspreid over Friesland. Met de metingen zijn voor de...
student report 2006
document
van Haaren, H.D. (author)
Failure of coastal protection due to flooding is mainly caused by a combination of high water level and waves. If one considers these as independent variables, the probability of failure can be calculated easily, but this would be an incorrect assumption. These two variables are de-pendent, so a method suitable for multivariate statistics is to...
master thesis 2005
Searched for: subject:"set%5C-up"
(1 - 12 of 12)