This paper uses 3D numerical analyses to investigate the stress path experienced by soil elements around large diameter piles in sand subjected to monotonic drained lateral loading. Inspection of the loading-induced stresses in the soil revealed the multiaxial nature of these stress paths, which are characterised by rotation of one or more principal stress axes. Based on the outcome of the finite element analyses, typical stress paths for different soil elements around the piles are extracted. Such stress paths are then evaluated against those enabled by conventional and advanced laboratory soil element testing. It is found that a combination of tests in the Hollow Cylinder Torsional Apparatus (HCTA) can reproduce most features of the numerically identified stress paths for soil elements around the pile. Unavoidable limitations in laboratory testing are discussed as well as the major challenge in replicating the loading direction with respect to the material axes. Some guidance for the experimental implementation of these stress paths in the HCTA are provided as well as a discussion on the use of conventional experimental equipment, such as the conventional triaxial or simple shear apparatus.

Based on advanced 3D finite element modelling, this paper analyses the stress paths experienced by soil elements in the vicinity of a monopile foundation for offshore wind turbines subjected to cyclic loading with the aim of informing soil laboratory testing in support of monopile foundation design. It is shown that the soil elements in front of the laterally loaded monopile are subjected to complex stress variations, which gradually evolve towards steady stress cycles as the cyclic lateral pile loading proceeds. The amplitude, direction and average value of such steady stress cycles are dependent on the depth and radial distance from the pile of the soil element, but it also invariably involves the cyclic rotation of principal stress axes. Complementary laboratory testing using the hollow-cylinder torsional apparatus was carried out on granular soil samples imposing cyclic stress paths (with up to about 3 × 104 cycles) which resemble those determined after 3D finite element analysis. The importance of considering the cyclic rotation of principal stress axes when investigating the response of soil elements under stress conditions mimicking those around a monopile foundation subjected to cyclic lateral loading is emphasised.