This paper investigates water injection effects in a simplified Ansaldo GT36 reheat system under realistic conditions of 20 atm using large eddy simulation (LES) coupled with thickened flame modeling and adaptive mesh refinement. The water injection conditions are optimized by performing a parametric study based on global sensitivity analysis (GSA) with a surrogate model based on Gaussian process (GP) to reduce computational cost. In particular, the influence of four design parameters, namely, Sauter mean diameter (SMD), water mass flow, and the angles of the spray's hollow cone, is tested to achieve an optimized solution. In the "dry"case, the LES simulations show several flashback events attributed to compressive pressure waves resulting from auto-ignition in the core flow near the crossover temperature. The use of water injection is found to be effective in suppressing the flashback occurrence. In particular, the global sensitivity analysis shows that the external angle of the spray cone and the mass flow of water are the most important design parameters for flashback prevention. NOx emissions are reduced by about 17% with water injection. Once an optimized condition with water injection is found, a recently proposed method to downscale the combustor to lower pressures is applied and tested. Additional LESs are performed for this purpose at the dry, unstable condition and the "wet,"stable condition. Results show that similar dynamics are predicted at 1 atm, validating the method's robustness. This provides avenues for experimentally testing combustion dynamics at simplified conditions which are still representative of high-pressure practical configurations.

This paper presents an investigation of the effects of water injection within a simplified version of the Ansaldo GT36 reheat system. The investigation is carried out under realistic operating conditions of 20 atm and using large eddy simulation (LES) coupled with the thickened flame model (TFM) and an adaptive mesh refinement. The water injection conditions are optimized by performing a parametric study based on global sensitivity analysis and a surrogate model based on Gaussian process is employed as a way to reduce computational cost. In particular, the influence on the system performance of four design parameters, namely Sauter mean diameter, water mass flow and the angles of the spray's hollow cone, is tested to achieve an optimized solution. In the 'dry' case, the LES simulations show several flashback events, which are a defining aspect of the considered conditions, and attributed to compressive pressure waves resulting from autoignition in the core flow near the crossover temperature. The use of water injection is found to be effective in suppressing the flashback occurrence. In particular, the global sensitivity analysis shows that the external angle of the spray cone and the mass flow of water are the most important design parameters for flashback prevention. Moreover, NOx was shown to be reduced by about 17% by the use of the water injection at the tested conditions. Once an optimised condition with water injection is found, a recently proposed method to downscale the combustor to lower pressures is applied and tested. Additional LES are performed for this purpose at the 'dry', unstable condition and the 'wet', stable condition. Results show that similar dynamics, respectively unstable and stable, is predicted at 1 atm, suggesting the robustness of the method. This provides avenues for experimentally testing combustion dynamics at simplified conditions which are still representative of high-pressure practical configurations.

In this study, the effects of water injection are analysed in a simplified geometry of a reheat combustor, which is based on a state of the art sequential reheat combustor from Ansaldo Energia. The inlet temperature of this burner and the chemical properties of hydrogen in terms of flame speed and autoignition imply that combustion occurs in an autoignition-assisted propagation regime. Large eddy simulations with an Artificial Thickened Flame modelling have been employed to analyse the dynamic behaviour of the hydrogen flame in lean premixed combustion mode. Results show that this approach can accurately predict the position of the flame front and the autoignition process as compared to a pre-existing DNS dataset. The flame front behaviour is further investigated, and observed to quickly move upstream and downstream, driven by the effect of pressure waves on the autoignition process. The study conducted here shows how the injection of water droplets can prevent the autoignition upstream and thus effectively help in achieving flame stability. Some light is also shed on the influence of the spray design parameters on the stability of the H₂ flame and the NOx emissions.