In forward osmosis, defects on the selective active layer and changes in the porous structure of the support layer can be detrimental factors affecting the membrane performance. This study focuses on the impacts of (i) the possible presence of defects and (ii) the changes in pore structures on the water flux and membrane selectivity via computational fluid dynamics analyses. Results suggest that diffusion of the draw solute through the support layer, i.e. internal concentration polarization, can be strongly enhanced or reduced by widening or narrowing the shape of the pore, respectively, while no significant effect on water permeation can be associated with the change in draw solution cross-flow velocity or in the loss of draw solute during filtration. Interestingly, defects within the active layer may affect the water flux exponentially as function of the defect size, suggesting the presence of a threshold below which the convective passage of contaminated water flux through the defect is not affecting the membrane productivity. Moreover, the presence of defects may not be a detrimental factor for membrane operating with high nominal rejection (>90%) and low percentage of defected area (<1%).

Aquaporin plays a promising role in fabricating high performance biomimetic forward osmosis (FO) membranes. However, aquaporin as a protein also has a risk of denaturation caused by various chemicals, resulting in a possible decay of membrane performance. The present study tested a novel aquaporin based biomimetic membrane in simulated membrane cleaning processes. The effects of cleaning agents on water flux and salt rejection were evaluated. The membrane showed a good resistance to the chemical agents. The water flux after chemical cleaning showed significant increases, particularly after cleaning with NaOCl and Alconox. Changes in the membrane structure and increased hydrophilicity in the surrounding areas of the aquaporin may be accountable for the increase in water permeability. The membrane shows stable salt rejection up to 99% after all cleaning agents were tested. A 15-day experiment with secondary wastewater effluent as the feed solution and seawater as the draw solution showed a stable flux and high salt rejection. The average rejection of the dissolved organic carbon from wastewater after the 15-day test was 90%. The results demonstrated that the aquaporin based biomimetic FO membrane exhibits chemical resistance for most agents used in membrane cleaning procedures, maintaining a stable flux and high salt rejection.