An early contamination warning system with deployed water quality sensors is often used to enhance the safety of a water distribution system (WDS). While algorithms have been developed to select an optimal water quality sensor placement strategy (WQSPS) for WDSs, many of them do not account for the influences caused by future uncertainties, such as sensor failures and system changes (e.g., demand variations and configuration/expansion changes in the WDS). To this end, this paper proposes a comprehensive framework to evaluate the robustness of WQSPSs to these possible uncertainties. This is achieved by considering five different performance objectives of WQSPSs as well as possible future demand and typology variations of WDSs under a wide range of sensor failure scenarios. More specifically, an optimization problem is formulated to evaluate the robustness of the WQSPSs, in which an evolutionary-based optimization approach coupled with an efficient data-archive method is used to solve this optimization problem. The framework is demonstrated on two real-world WDSs in China. The results show that: (1) the WQSPS's robustness can be highly dependent on the performance objectives considered, implying that an appropriate objective needs to be carefully selected for each case driven by practical needs, (2) the WDS's demand and configuration changes can have a significant influence on the WQSPS's robustness, in which the solution with more sensors in or close to the affected area is likely to better cope with these system changes, and (3) the proposed framework enables critical sensors to be identified, which can then be targeted for prioritizing maintenance actions.

Most of the contamination source localization methods for water distribution systems (WDSs) assume the availability of accurate water quality models and multi-parameter online sensors, which are often out of reach of many water utilities. To address this, a novel manual grab-sampling method (MGSM) is developed to effectively and efficiently locate continuous contamination sources in a WDS using a dynamic and cyclical sampling strategy. The grab samples are collected at a pre-specified number of hydrants by the corresponding teams followed by laboratory tests. The MGSM optimizes the sampling plan at each cycle by making the probability of contamination source(s) in each sub-network as equal as possible, where sub-networks are determined by the selected hydrants and current flow pipe directions. The CS's size is reduced at each cycle by exploiting sample testing results obtained in the previous cycle until there are no further hydrants to sample from. Two real-world WDSs are used to demonstrate the effectiveness of the proposed MGSM. The results obtained show that the MGSM can significantly reduce the spatial range of the CS (to about 5% of the entire WDS) for a range of scenarios including multiple contamination sources and pipe flow direction changes. We found that an optimal number of sampling teams exists for a given WDS, representing a balanced trade-off between detection efficiency and sampling/testing budgets. Due to its relative simplicity, the proposed MGSM can be used in engineering practice straightaway and it represents a viable alternative to the methods associated with water quality models and sensors.