Long Range Wide Area Networks (LoRaWAN) offer ubiquitous communications for The Internet of Things (IoT). However, there are many challenges in rolling out LoRaWAN - mainly scalability, energy efficiency, Packet Reception Ratio (PRR), and keeping the channel access as simple as unslotted ALOHA. To this end, we design non-persistent Capture Effect Channel Activity Detection Algorithm (np-CECADA), which is a novel, distributed protocol for the MAC layer of LoRaWAN. It utilizes Channel Activity Detection (CAD), which is a built-in imperfect mechanism for channel sensing and minimal feedback from the gateways. In np-CECADA each device independently adapts backoff times based on the traffic in its vicinity and the transmission power based on the heuristically inferred probability of capturing the channel. To achieve this, first, we carried out an extensive on-field evaluation to measure the effectiveness of CAD and capture effect in LoRa. Using them we designed np CECADA and developed ns-3 modules. Packet Reception Ratio of np-CECADA is 15.74× and 5.13× higher than vanilla LoRaWAN and p-CARMA, respectively. Channel utilization is 11.24× higher compared to LMAC. Further, on a testbed of 30 LoRa devices np-CECADA outperforms LoRaWAN up to 5 times.@en

Due to power limitations and coexistence in ISM bands, up to 50% of the Long Range (LoRa)-frames are corrupted at low signal strengths (≈ -115dBm) and the built-in redundancy schemes in LoRa-Wide Area Network (LoRaWAN) cannot correct the corrupted bytes. To address this, higher Spreading Factors (SF) are used resulting in wasted energy, increased traffic load, and highly compromised effective data rate. Our on-field experiments showed a high correlation in the corruption of close-by frames. We propose a novel Divide & Code (DC) scheme for LoRaWANs as an alternative to using higher SF. DC pre-encodes LoRa payloads using lightweight and memoryless encoding. After receiving a corrupted frame, DC uses a combination of most probable patterns of errors, Time Thresholds (TT), and splitting of payloads into subgroups for batch processing to recover frames effectively and maintain low complexity and timely operation. By implementing DC on our LoRa-testbed, we show it outperforms vanilla-LoRaWAN and Reed-Solomon codes in decoding and energy consumption. Our schemes decode up to 80.5% of corrupted payloads on SF10 by trying only 0.03% of all patterns of error combinations. TT keeps processing times below 2 ms with only minor reductions in the decoding ratio of corrupted payloads. Finally, we showcase that introducing 30% redundancy with DC results in minimum energy consumption and high decoding ratio at low SNRs. @en

High frame-corruption is widely observed in Long Range Wide Area Networks (LoRaWAN) due to the coexistence with other networks in ISM bands and an Aloha-like MAC layer. LoRa's Forward Error Correction (FEC) mechanism is often insufficient to retrieve corrupted data. In fact, real-life measurements show that at least one-fourth of received transmissions are corrupted. When more frames are dropped, LoRa nodes usually switch over to higher spreading factors (SF), thus increasing transmission times and increasing the required energy. This paper introduces ReDCoS, a novel coding technique at the application layer that improves recovery of corrupted LoRa frames, thus reducing the overall transmission time and energy invested by LoRa nodes by several-fold. ReDCoS utilizes lightweight coding techniques to pre-encode the transmitted data. Therefore, the inbuilt Cyclic Redundancy Check (CRC) that follows is computed based on an already encoded data. At the receiver, we use both the CRC and the coded data to recover data from a corrupted frame beyond the built-in Error Correcting Code (ECC). We compare the performance of ReDCoS to (i) the standard FEC of vanilla-LoRaWAN, and to (ii) Reed Solomon (RS) coding applied as ECC to the data of LoRaWAN. The results indicated a 54x and 13.5x improvement of decoding ratio, respectively, when 20 data symbols were sent. Furthermore, we evaluated ReDCoS on-field using LoRa SX1261 transceivers showing that it outperformed RS-coding by factor of at least 2x (and up to 6x) in terms of the decoding ratio while consuming 38.5% less energy per correctly received transmission.@en