In this paper, we investigate the high-speed dynamics of symmetric and asymmetric cavitation bubble-collapse. For this purpose, a sharp-interface numerical model is employed, that includes a numerically efficient evaporation/condensation model. The underlying assumption is that phase change occurs in thermal non-equilibrium and that the associated timescale is much larger than that of the wave-dynamics described by the interfacial Riemann problem. The sharp-interface model allows for an accurate tracking of the interface evolution throughout collapse and rebound. With a first set of simulations, we investigate the influence of the non-equilibrium on the relaxation behaviour of an oscillating vapour bubble. We observe that a good prediction of the phase-change rate is essential. Of high practical interest is the collapse of cavitation bubbles near walls under high ambient-pressure conditions. We investigate the differences in collapse evolution for detached and attached bubbles. It is shown that the maximum wall pressure strongly depends on the symmetry of the collapse mechanisms, and regions with a high probability of bubble rebound are identified. Asymmetric attached bubbles lead to significantly different topology changes during collapse than symmetric bubbles but exhibit roughly the same range of maximum pressures.@en

In most technical applications involving cavitation, vapor bubbles occur in clouds, and their collapse is affected by the interaction with neighboring bubbles. One approach to study the influence of these interactions is the investigation of the collapse of cavity arrays in water under shock wave loading. We describe in detail the collapse mechanisms during the collapse of a horizontal cavity array, with particular consideration of maximum pressures. As general trend, we find a pressure amplification in consecutive cavity collapses. However, by increasing the number of cavities, we are able to demonstrate that the amplification is not monotonic. A parameter study of the bubble separation distance in horizontal arrays shows that a smaller distance generally, but not necessarily, results in larger collapse pressure. Exceptions from the general trend are due to the very complex shock and expansion-wave interactions and demonstrate the importance of using state-of-the-art numerical methods. By varying boundary conditions, we illustrate the significance of large test sections in experimental investigations, as the expansion wave emitted at a free surface has a large effect on the collapse dynamics.@en

In order to perform Implicit Large Eddy Simulation (ILES) on complex geometries at high Reynolds numbers, a wall model based on the simplified Thin Boundary Layer Equations (TBLE) is designed in the framework of ILES with a cut-cell finite-volume immersed boundary method. This wall model is validated for turbulent channel flow at friction Reynolds number up to Reτ = 2,000 on very coarse grids. The results compared with DNS and LES without wall model show that the wall model has the potential to improve the mean velocity in the outer flow region well at high Reynolds number. The wall model is applied to a complex converging diverging channel flow at Reynolds number Re = 7,900 on very coarse meshes. Improved mean velocities and Reynolds stresses are obtained, which shows that the wall model has the ability to perform ILES on complex geometries at high Reynolds numbers.@en