New 7xxx aluminum alloys with high alloying contents are being designed, which could induce serious hot tearing defects during direct-chill (DC) casting. Among all factors affecting hot tearing of 7xxx alloys, undoubtedly alloying elements play a significant role. In this study, the effect of main alloying elements (Zn, Mg, and Cu) on hot tearing of grain-refined Al-xZn-yMg-zCu alloys was investigated by a dedicated hot tearing rating apparatus simulating the DC-casting process. It was found that the minimum and maximum hot tearing susceptibilities occur for 4 to 6 and 9 wt pct Zn, respectively, indicating the complicated effect of Zn content. The hot tearing resistance of grain-refined Al-9Zn-yMg-zCu alloys is enhanced with increasing Mg content but is deteriorated with increasing Cu content. This can be attributed to the interaction of the thermal stresses, melt feeding, and final eutectics. The observed tendencies of the main alloying elements on hot tearing were also confirmed for four commercial 7xxx alloys. In addition, both the load value at non-equilibrium solidus and the SKK criterion proposed by Suyitno et al. using measured load developments were found to be good indicators in predicting hot tearing susceptibility. This study can provide a beneficial guide in designing 7xxx alloys considering the potential occurrence of hot cracks beforehand.

The effect of Zn addition on the hot tearing susceptibilities of non-refined Al-xZn-2Mg-2Cu (x = 2-12 wt pct) alloys was investigated via direct crack observations and load response measurements. The obtained experimental results were compared with the predictions made using a modified Rappaz–Drezet–Gremaud (RDG) hot tearing model. Both the minimum crack width and load at the non-equilibrium solidus (NES) temperature (which served as a good indicator of hot tearing response) were observed at a Zn concentration of approximately 4 wt pct, and the formation of cracks was highly correlated with the predictions made via the modified RDG hot tearing model (although the obtained relationship critically depended on the magnitude of fraction solid at which solid coalescence was expected to occur). Furthermore, it was confirmed from the load development pattern that the addition of Zn into the matrix of Al-xZn-2Mg-2Cu alloys promoted the formation of coalesced networks, which decreased their corresponding coalescence fraction solids.