The Goos-Hänchen (GH) shift describes a phenomenon in which a specularly reflected beam is translated along the reflecting surface such that the incident and reflected rays no longer intersect at the surface. Using a neutron spin-echo technique and a specially designed magnetic multilayer mirror, we have measured the relative phase between the reflected up and down neutron spin states in total reflection. The relative GH shift calculated from this phase shows a strong resonant enhancement at a particular incident neutron wave vector, which is due to a waveguiding effect in one of the magnetic layers. Calculations based on the observed phase difference between the neutron states indicate a propagation distance along the waveguide layer of 0.65 mm for the spin-down state, which we identify with the magnitude of the giant GH shift. The existence of a physical GH shift is confirmed by the observation of neutron absorption in the waveguide layer. We propose ways in which our experimental method may be exploited for neutron quantum-enhanced sensing of thin magnetic layers.

We present a resonant-mode, transverse-field, radio-frequency (rf) neutron spin flipper design that uses high-temperature superconducting films to ensure sharp transitions between uniform magnetic field regions. Resonant mode allows for low-power, high-frequency operation but requires strict homogeneity of the magnetic fields inside the device. This design was found to efficiently flip neutrons at 96.6 ± 0.6% at an effective frequency of 4 MHz in bootstrap configuration with a beam size of 2.4 × 2.5 cm2 and a wavelength of 0.4 nm. The high frequency and efficiency enable this device to perform high-resolution neutron spectroscopy with comparable performance with currently implemented rf flipper designs. The limitation of the maximum frequency was found due to the field homogeneity of the device. We numerically analyze the maximum possible efficiency of this design using a Bloch solver simulation with magnetic fields generated from finite-element simulations. We also discuss future improvements of the efficiency and frequency to the design based on the experimental and simulation results.