Resistance measurements on power transformers are offline diagnostic methods that are performed without opening the transformer main tank. In case the power transformer is equipped with an on-load tap changer (OLTC), this resistance measurement can be used to find degradation and defects inside the OLTC. Many OLTC defects as well as contact degradation can be measured by means of dynamic resistance measurements, which is a resistance test during OLTC operation. A low (DC) test current through the on-load tap changer is used during dynamic resistance measurements. This method is in particular sensitive to maintenance errors, contact degradation and contact timing problems. In general, distinction can be made between defects that interrupt the current through the OLTC, defects that affect the timing of the OLTC contacts and contact degradation resulting in abnormal contact resistance.@en

Static resistance measurements on power transformers give an indication about increased contact resistances of the OLTC. Increased contact resistances can also be measured by means of a dynamic resistance measurement (DRM). This paper elaborates on condition diagnosis of electrical contacts of in-tank high-speed resistor tap changers using DRM. DRM uses a low test current through the on-load tap changer to detect increased contact resistances and current interruptions. The difference with static resistance measurements is that the tap changer is switched through all its tap positions during the test. The test current gets no change to fully stabilize due to the inductance of the transformer windings. DRM is therefore less accurate then static resistance measurements but contains more information about the type and location of tap changer defect. This contribution will show that more defects on OLTC's can be found with DRM compared to static resistance tests: the additional value of DRM compared to static winding resistance measurements is discussed. Secondly, important topics that should be considered when performing dynamic resistance measurements are discussed, like the effect of the test current amplitude, the secondary short-circuit and circuit resistance. Simulation results and experimental data are presented to make the reader familiar with the pros and cons of dynamic resistance measurements.@en

For advanced, non-destructive on-site condition monitoring of HV power cables up to 150kV by partial discharge detection and dielectric losses measurement it is necessary to energize the disconnected cable system. One of the methods available for this purpose is based on applying damped AC voltages up to 150kV. In this paper, the use of modern technological solutions in power electronics and signal processing as well as in technical design and production methods will be discussed on the basis of the ultra light system (300kg) which is able to test cables up to 20km lengths.@en