An oxide dispersion strengthened (ODS) steel with nominal composition Fe–14Cr–2W–0.4Ti–0.3Y2O3 (wt%) has been manufactured by mechanical alloying of pre-alloyed powders with nanosized Y2O3, compacted by hot isostatic pressing and hot cross rolled. In order to evaluate the long-term thermal resistance of the alloy, it has been subjected to 2000 h of thermal aging at 873 K, which is a relevant temperature for nuclear reactor applications. A thermodynamic equilibrium simulation indicates the precipitation of Laves phase under the aging parameters used. This prediction is confirmed from the detailed multi-technique characterization performed. Before aging, Ti-rich oxides, Cr-W-rich precipitates (M23C6 type) and a homogeneous Y-rich nanoprecipitate dispersion are observed. After aging, some W-rich precipitates are identified as Laves phase, while M23C6 carbides, Ti-rich oxides and Y-rich nanoprecipitates remain stable. Mechanical characterization performed in a previous research showed higher hardness, a loss of total elongation and a slight shift of the ductile-to-brittle transition temperature (DBTT) towards a higher value after aging, with similar strength values before and after the long-term thermal treatment. These changes can be due to the redistribution of precipitates together with the Laves phase formation. The mechanical properties not being dramatically affected seem to be due to the observed stability of Y-rich nanoprecipitates distribution.@en

An ODS steel with nominal composition Fe–14Cr–2W–0.4Ti-0.3Y2O3 (wt.%) was produced by mechanical alloying and compacted by hot isostatic pressing (HIP) followed by hot cross rolling (HCR). To check the effects of thermal aging at relevant temperatures of operation in fusion power plants, the alloy was thermally aged at 873 K for 2000 h. In this work, small-angle neutron scattering (SANS) and X-ray absorption spectroscopy (XAS) techniques are used for the advanced characterization of secondary phases and the oxide nanoparticle dispersion. SANS results show that the oxide nanoparticles remain stable after the thermal aging treatment. Composition of the oxide nanoparticles was identified as Y2TiO5 or Y2Ti2O7 by SANS, while non-stoichiometry was found by XAS analysis. Laves phase precipitation after the thermal aging treatment is further confirmed by SANS, from the magnetic anisotropic contribution to the scattering intensity associated to this metallic phase, and by XANES.@en

An ODS steel with nominal composition Fe–14Cr–2W–0.4Ti-0.3Y2O3 (wt.%) was produced by mechanical alloying and compacted by hot isostatic pressing (HIP) followed by hot cross rolling (HCR). To check the effects of thermal aging at relevant temperatures of operation in fusion power plants, the alloy was thermally aged at 873 K for 2000 h. In this work, small-angle neutron scattering (SANS) and X-ray absorption spectroscopy (XAS) techniques are used for the advanced characterization of secondary phases and the oxide nanoparticle dispersion. SANS results show that the oxide nanoparticles remain stable after the thermal aging treatment. Composition of the oxide nanoparticles was identified as Y2TiO5 or Y2Ti2O7 by SANS, while non-stoichiometry was found by XAS analysis. Laves phase precipitation after the thermal aging treatment is further confirmed by SANS, from the magnetic anisotropic contribution to the scattering intensity associated to this metallic phase, and by XANES.@en