In-service turbine monitoring is essential for maximizing the wind energy contribution to the global energy budget. Measurement of turbine shaft torque under transient wind conditions is fundamental to develop reliable condition monitoring techniques. Contact based measurements bring their own disadvantages and non-contactless measurements have many potential advantages. However, their performance needs to be validated against standard methods. This paper focuses on the development of an enhanced transient Feature Selective Validation (FSV) techniques to undertake this analysis with an emphasis on transient data processing. The nature of FSV makes it a natural technique to consider for this problem space. Open questions have existed as to how transients should be dealt with in FSV. This paper overcomes the limitations of previous approaches for step-function transient comparison and presents analytical methods to ensure the transient feature itself is considered, irrespective of how much pre- and post- transient data happens to be included.

This paper presents a discussion of the development of wind energy generation in the United Kingdom and the challenges faced by the wind industry including reliability, performance and condition monitoring, particularly in the offshore environment. The worldwide installed capacity of offshore wind has now risen to over 7 GW, with an ever increasing deployment rate of new assets. About 90% of the global currently installed capacity is in Northern Europe, with the United Kingdom having the world's largest share at 4 GW. Capacity factor data from UK offshore wind farms is presented, providing an insight into the current performance of large Round 2 offshore wind farms compared to the earlier Round 1 farms and to onshore farms. The data reveal that the United Kingdom's Round 2 offshore farms are achieving an average monthly capacity factor of 38.3% with a peak value of 75.8%. The older Round 1 farms have a lower average capacity factor of 33.6% while large onshore farms with capacities above 100 MW have achieved 25.6%. Offshore wind turbine performance has improved over time, and the industry is applying the learning from early experiences to achieve better performances at the more recently installed farms. Despite these improvements in turbine availability, the cost of energy from wind, particularly offshore, remains too high for it to be a commercially viable form of generation without subsidies. Reducing the cost of energy from wind to economically sustainable levels is the most important challenge facing the industry today. Operation and maintenance costs constitute up to 30 % of the total cost of energy from wind in large farms. The industry must overcome the challenges associated with improving component reliability and the development and adoption by operators of appropriate condition monitoring systems and maintenance strategies, in order to reduce costs to sustainable levels. Research and development work carried out with these goals in mind is also reviewed in the paper.

Wind turbine condition monitoring is gaining in importance as operators and developers move towards larger, further offshore, less accessible wind farms. However, condition monitoring is made highly challenging by the variable speed, variable load nature of wind turbines. Electrical faults, in the form of brush gear or slip ring damage contribute significantly to downtime yet operators have little experience of detecting these faults in the field. This paper subjects a physical test rig to rotor electrical unbalances and applies a frequency tracking algorithm to mechanical and electrical monitoring signals to compare the sensitivity of the various signals. The results shows that the total electrical power signal gives the clearest response to rotor electrical unbalance, as expected, but that torque measurements could be a viable alternative. Speed signal analysis showed much lower sensitivity to unbalance than torque or power measurements.