Salt crystallization is a major cause of damage in porous building materials. Accelerated salt weathering tests carried out in the laboratory are among the most common methods to assess the durability of material to salt decay. However, existing standards and recommendations for salt weathering tests have limitations in terms of effectiveness and/or reliability. In the framework of the RILEM Technical Committee 271-ASC, a procedure has been developed which proposes a new approach to salt crystallization tests. It starts from the consideration that salt damage can be seen as a process developing in two phases: accumulation of the salt in the material and propagation of the decay. In the first phase, salts are introduced in the material and accumulate close to the evaporation surface, while in the second phase damage propagates because of repeated dissolution and crystallization cycles, induced by re-wetting with liquid water and by relative humidity changes. In this paper, the procedure is described and the results of a first round robin validation of the test, carried out on 7 materials and involving 10 laboratories, are presented. The results show that the procedure is effective to cause decay within the time period of the test (about 3 months) and that the decay increases with subsequent cycles. The decay observed differs in type and severity depending on the salt type and concentration and on the type of substrate. The decay types detected in the laboratories are generally representative of those observed in the field for the selected substrates. The differences in durability between the various substrates, as assessed at the end of the test, are in line with the durability expected based on field observation. The reproducibility of the results in terms of decay type is good; some differences have been observed in terms of material loss. These are more significant in the case of NaCl contaminated specimens. Based on the results, proposals for fine-tuning of the procedure are given.@en

Salt crystallization represents one of the major causes for the degradation of building and ornamental stone. As such, it has attracted the attention of researchers, who over the years have progressively unraveled most mechanisms involved in salt damage. Despite this mechanistic understanding, many questions subsist about how to quantitatively predict damage or its progression, and in particular how to relate performance on site to that in laboratory tests. In this context, a new RILEM TC 271‐ASC has been started with the objective of defining laboratory tests that deliver more reliable predictions of field behavior. One deliverable of this TC is to provide a theoretical insight into this question based on recent progress on the understanding of salt damage. This paper presents a summary of this work, highlighting key aspects relating to crystallization pressure, chemo‐mechanics and mass transport. Implications are discussed in relation to the most used accelerated salt crystallization tests in an attempt to better define which field exposure conditions that these tests best represent and may be used for, or define effective test procedures representing specific field conditions. A simple conceptual model for the development of salt damage is introduced. During an initial “induction” phase, transport of ions and accumulation of salt in the porous materials occurs without causing detectable damage until a critical point, termed “damage onset” is reached. Beyond this point, during the “propagation phase”, the material degrades, typically losing strength and cohesiveness. The implications of these two phases are discussed in relation to the selection of appropriate salt weathering tests and conservation interventions.@en