A drinking water distribution system (DWDS) is a critical and a costly asset with a long lifetime. Drinking water demand is likely to change in the coming decades. Quantifying these changes involves large uncertainties. This paper proposes a stress test on the robustness of existing DWDS under changing drinking water demands. The stress test investigates the effects of extreme but plausible demand scenarios on the network performance. Two layouts, one conventional looped designed for fire flows and one designed as a self-cleaning, were tested. For 12 demand scenarios, diurnal patterns were simulated with the end-use model SIMDEUM. The performance of the network was evaluated on three criteria: (1) network pressure, (2) water quality, and (3) continuity of supply. Although the self-cleaning layout had higher head losses, it performed better regarding water quality than the conventional layout. Both networks are robust to the extremities of drinking water demands. The stress test is useful to quantify the performance range of the DWDS. For non-Dutch locations, the criteria and scenarios can be adapted to local conditions @en

Reducing water use could impact existing sewer systems but this is not currently well understood. This work describes a new flow and wastewater quality model developed to investigate this impact. SIMDEUM WW® was used to generate stochastic appliance-specific discharge profiles for wastewater flow and concentration, which were fed into InfoWorks® ICM to quantify the impacts within the sewer network. The model was validated using measured field data from a sewer system in Amsterdam serving 418 households. Wastewater concentrations of total suspended solids (TSS), chemical oxygen demand (COD), total Kjeldahl nitrogen (TKN) and total phosphorus (TPH) were sampled on an hourly basis, for one week. The results obtained showed that the InfoWorks® model predicted the mass flow of pollutants well (R-values 0.69, 0.72 and 0.75 for COD, TKN and TPH respectively) but, due to the current lack of a time-varying solids transport model within InfoWorks®, the prediction for wastewater concentration parameters was less reliable. Still, the model was deemed capable of analysing the effects of three water conservation strategies (greywater reuse, rainwater harvesting and water-saving appliances) on flow, nutrient concentrations, and temperature in sewer networks. Results show through a 62% reduction in sewer flow, COD, TKN and TPH concentrations increased by up to 111%, 84% and 75% respectively, offering more favourable conditions for nutrient recovery.@en

Domestic drinking water supply systems (DDWSs) are the final step in the delivery of drinking water to consumers. Temperature is one of the rate-controlling parameters for many chemical and microbiological processes and is, therefore, considered as a surrogate parameter for water quality processes. In this study, a mathematical model is presented that predicts temperature dynamics of the drinking water in DDWSs. A full-scale DDWS resembling a conventional system was built and run according to one year of stochastic demands with a time step of 10 s. The drinking water temperature was measured at each point-of-use in the systems and the data-set was used for model validation. The temperature model adequately reproduced the temperature profiles, both in cold and hot water lines, in the full-scale DDWS. The model showed that inlet water temperature and ambient temperature have a large effect on the water temperature in the DDWSs. @en