This project aims at finding cost-efficient sets of measures to meet the Water Framework Directive (WFD) derived goals for the Dommel River (The Netherlands). Within the project, both acute and long-term impacts of the urban wastewater system on the chemical and ecological quality of the river are studied with a monitoring campaign in the urban wastewater system (wastewater treatment plant and sewers) and in the receiving surface water system. An integrated model, which proved to be a powerful tool to analyse the interactions within the integrated urban wastewater system, was first used to evaluate measures in the urban wastewater system using the existing infrastructure and new real-time control strategies. As the latter resulted to be beneficial but not sufficient, this paper investigated the use of additional infrastructural measures to improve the system cost-effectively and have it meet the Directive's goals. Finally, an uncertainty analysis was conducted to investigate the impact of uncertainty in the main model assumptions and model parameters on the performance robustness of the selected set of measures. Apart from some extreme worst-case scenarios, the proposed set of measures turned out to be sufficiently robust. Due to the substantial savings obtained with the results of this project, the pay-back time of the whole monitoring and modelling work proved to be less than 5 months. This illustrates the power of mathematical modelling for decision support in the context of complex urban water systems ... Read more

Modeling of integrated urban water systems (IUWS) has seen a rapid development in recent years. Models and software are available that describe the process dynamics in sewers, wastewater treatment plants (WWTPs), receiving water systems as well as at the interfaces between the submodels. Successful applications of integrated modeling are, however, relatively scarce. One of the reasons for this is the lack of high-quality monitoring data with the required spatial and temporal resolution and accuracy to calibrate and validate the integrated models, even though the state of the art of monitoring itself is no longer the limiting factor. This paper discusses the efforts to be able to meet the data requirements associated with integrated modeling and describes the methods applied to validate the monitoring data and to use submodels as software sensor to provide the necessary input for other submodels. The main conclusion of the paper is that state of the art monitoring is in principle sufficient to provide the data necessary to calibrate integrated models, but practical limitations resulting in incomplete data-sets hamper widespread application. In order to overcome these difficulties, redundancy of future monitoring networks should be increased and, at the same time, data handling (including data validation, mining and assimilation) should receive much more attention. ... Read more