Monitoring structural behavior of earth structures during construction and in service is a common practice done for safety reasons, consolidation control and maintenance needs. Several are the techniques available for measuring displacements, water pressures and total stresses, not only in these geotechnical structures but also at their foundations. Materials testing has been used for calibrating models for structural design and behavior prediction, and these models can be validated with instrumentation data as well. Relatively recent investigation on the behavior of these materials considering their degree of saturation focuses on monitoring the evolution of water content or suction as function of soil-atmosphere interaction, necessary to predict cyclic and/or accumulated displacements, and has huge potential to predict the impact of climate changes on the performance of existing geotechnical structures. This new need justifies the investment on developing sensors able to be used for in situ monitoring of water in the soils, such as those presented here. Testing and monitoring becomes even more important nowadays when, for sustainability purposes, traditional construction materials are replaced by other geo-materials with unknown behavior and long-term performance (mainly accumulated displacements). Existing experimental protocols and monitoring equipment are used for such cases, however new techniques must be developed to deal with particular behaviors. Three case studies are presented and discussion is made on monitoring equipment used and how monitored data helped understanding the behaviors observed.

Failures that occurred in the last few decades highlighted the need to raise awareness about the emergent risk related to the impact localised degradation phenomena have on embankments. Common interventions aimed to improve embankments, such as the reconstruction of the damaged area or the injection of low-pressure grouts to fill fractures and burrows, may cause the weakening of the structure due to discontinuities between natural and treated zones. Moreover, since such repair techniques require huge volumes of materials, more sustainable solutions are encouraged. At the same time, the textile and fashion industries are looking for sustainable waste management and disposal strategies to face environmental problems concerned with the voluminous textile waste dispatched to landfills or incinerators. The use of soil mixed with textile waste in embankment improvement has been investigated to identify an effective engineering practice and to provide a strategy for the circular economy of textiles. Preliminary laboratory tests have been conducted on soil specimens collected from the Secchia River embankment, Northern Italy, to define the appropriate mixture proportions and to compare physical properties and hydro-mechanical behaviour of natural and treated soils. The results show that an appropriate fibre content offers manageable and relatively homogeneous mixtures. The indluence on soil consistency is mainly due to the textile fibre hydrophilic nature. The addition of fibres reduces the maximum dry density and increases the optimum water content. At low stress levels, the compressibility and hydraulic conductivity appear higher, however macro voids produced during sample preparation may alter the findings.

In spite of the increasing diffusion of tunnel boring machines, conventional tunnelling is still preferred for economic reasons in case of short tunnels, unconventional cross sections or irregular tunnel trajectories. In conventional tunnelling, the mechanical response of the tunnel front is a main concern and, when tunnels are excavated in cohesive soils, this is dominated by the time factor, related to geometry, to the mean excavation rate and to the hydro-mechanical properties of the materials involved. This is particularly evident during excavation standstill: front displacements progressively increase with time and, in many cases, the system response under long-term conditions becomes unstable. In conventional tunnelling, a common technique employed to improve the system response (under both short- and long-term conditions) is the installation of fibreglass tubes within the advance core. In this paper, the mechanical response of both unreinforced and reinforced deep tunnel fronts in cohesive soils is experimentally analysed. In particular, the results of a series of 1 g small-scale tests, taking into account both the influence of the excavation rate (the unloading time) on the system response and the evolution with time of the tunnel face displacements, induced by a rapid reduction in the horizontal stress applied on the tunnel face, are reported.