To assess the shear properties of masonry for existing buildings, the shove test method proposed by ASTM C1531 can be carried out, in which the load required to slide a single brick with respect to the surrounding masonry is measured. To control the vertical stress-state on the tested brick, two flat-jacks can be inserted in mortar bed joints in close proximity of it, thus prescribing a predefined level of compression. Although this test seems straightforward, uncertainties have not been resolved yet regarding the actual vertical compressive stress present on the tested brick and the effect of dilatancy. To gain a better insight into the shear-sliding behavior of masonry during the shove test, both experimental tests and numerical simulations were considered in the current research. To analyze these aspects and to precisely define a testing protocol, the experimental tests were performed in a controlled laboratory environment on a single wythe calcium silicate brick masonry wall. In parallel, numerical analyses were carried out using a simplified micro-modeling strategy, in which every brick was modelled, and the mortar joints were considered as zero-thickness interfaces. A composite interface model was used, including a tension cut-off, a Coulomb friction domain and a compressive cap. For the analyzed case study, the numerical results allowed to gain a better understanding of the aspects influencing the shear-sliding behavior of masonry during the shove test.@en

The shove test (ASTM Standard C1531) is an experimental technique aimed at studying the shear-sliding behavior of brick masonry. It can be executed according to various testing methods that differ in the way the vertical compression load is applied and in the way bricks and/or joints are locally removed for inserting jacks. One of the most critical aspects is the correct evaluation of the compressive stress state on the sliding brick. The objective of the present paper is to investigate the capability of the shove test in determining the shear strength parameters of brick masonries and to highlight the main advantages and disadvantages of the various testing methods. To this aim, nonlinear numerical simulations of the shove test were performed by adopting a brick-to-brick modeling strategy. The 2D numerical model was calibrated and validated through comparisons with experimental results of triplet tests and shove tests. The numerical analyses allowed to understand the influence the different testing methods and the masonry mechanical properties, such as dilatancy, may have on the test results. Based on the numerical outcomes, correction factors were calibrated for the proper evaluation of the compressive stress state on the sliding brick. Improvements with regards to the experimental procedures, i.e. additional test phases and measurements, were also proposed to enhance the results interpretation.@en